Dell PP04X specifications

As the computer boots, it detects the additional memory and automatically updates the system configuration information.

To confirm the amount of memory installed in the computer, click Start, click Help and Support, and then click Computer Information.

To install a memory module in DIMM B:

1.Follow the procedures in Before You Begin.

2.Turn the computer upside-down, loosen the captive screw on the memory module cover, and then remove the cover.

1 captive screw

NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory-module securing clips.

3.If you are replacing a memory module, remove the existing module:

a.Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.

b.Remove the module from the connector.

1 memory module 2 securing clips (2)

NOTICE: If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMMA" before you install a module in the connector labeled "DIMMB." Insert memory modules at a 45-degree angle to avoid damaging the connector.

NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.

4.Ground yourself and install the new memory module:

a.Align the notch in the module edge connector with the tab in the connector slot.

b.Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.

5.Replace the memory module cover and tighten the screw.

NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer.

6. Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.