Code Alarm CR3 manual Cabled Operation, Introduction

1.6 - Cabled Operation

1.6.1 - Introduction

The CR3 is available with USB, RS232 and PS2 cables. All of the cables are connected to the CR3 with a 8-pin DIN connector. Different cables may be required for different hosts.

Hand Held CR3 - To install a cable on the standard palm-held unit, correctly line up the 8-pin DIN connector into back end of the unit. The arrows on the connector should be facing down (Figure 1.2). When they are lined up, fi rmly push the cable in. The cable has a locking mechanism that will fi rmly hold the cable in place (Figure 1.3). To detach the cable from the reader, YOU MUST grip the plastic on the 8-pin din (Figure 1.4) and pull back to disengage the connector.

CR3 with Handle - If you purchased one of Code’s cabled handle accessories, the 8-pin DIN connector is on the bottom of the handle (Figure 1.4). Insert the 8-pin connector and fi rmly push the cable into the handle. The cable has a locking mechanism that will fi rmly hold the cable in place. To detach the cable from the reader, YOU MUST grip the plastic on the 8-pin DIN (Figure 1.5) and pull back to disengage the connector.

When using the H2 ruggedized handle, an extra clip is available to attach the cable to the handle with two threaded screws (Figure 1.6).

Figure 1.2 Figure 1.3

Figure 1.4

Figure 1.5 Figure 1.6

Save Settings C002332_09_CR3 User Manual - 7