Save Settings
Scan the code below to make the RF settings permanent on the reader:
Save Settings
Disconnecting from the Device
You may force disconnection by reading the disconnect code below (The CR3 may not appear disconnected in the slave Bluetooth connection manager for 10 – 15 seconds after the command is issued). The CR3 will also disconnect after 90 seconds of inactivity (Note: You may change the radio sleep time out setting; however, it may reduce battery life).
Bluetooth Disconnect
Reconnecting to the Device
If the device is saved in RF mode and has a save connection (save was performed while connected) it will automatically reconnect when:
1.CR3 is powered up
2.CR3 wakes from sleep mode
3.CR3 reads another code
Note: To set up more than one device, please consult Appendix F: “QuickConnect Codes”
1.7.2 - Bluetooth Radio Auto Connect
Auto Connect: After coming out of sleep mode or after powering up the CR3 tries to auto connect with the last Bluetooth radio with which it was connected if the steps (previous) were followed (see Section
1.7.1- Connecting with a Quick Connect Code). You may also
code.
Scan the following codes to enable or disable Auto Connect feature for the Bluetooth radio:
Bluetooth Radio Auto Connect: On (Default) | Bluetooth Radio Auto Connect: Off |
Save Settings | C002332_09_CR3 User Manual - 16 |