2.11 - Continuous Scan Settings
2.11.1 - Continuous Scan - Sleep Time Out
Scan one of the codes below to set the amount of time a cabled CR3 will operate in continuous scan mode before entering sleep mode:
Cabled - 2 hours | Cabled - Always (Default) |
Scan one of the codes below to set the amount of time an uncabled CR3 will operate in continuous scan mode before entering sleep mode:
Uncabled - 5 minutes (Default) | Uncabled - 15 Minutes | Uncabled - 30 Minutes |
Note: This function is only recommended for short term use because of battery consumption.
2.11.2 - Continuous Scan - Trigger Delays
Scan the following codes to set delay time between scans:
0 Seconds (Default) | 1 Second | 3 Seconds |
2.11.3 - Continuous Scan - Duplicate Scan Suppression
Scan the following codes to set the period of time during which duplicate codes are ignored:
0 Seconds (Default) | 1 Second | 3 Seconds |
2.12 - Motion Detection Scan Settings
Scan the following codes to set the reader to read when it detects motion in its scanning zone.
Motion Detection On | Motion Detection Off |
Save Settings | C002332_09_CR3 User Manual - 31 |