4.11 - Lock-out Link Mode
To establish a permanently linked connection between the reader and a CodeXML modem, you must fi rst scan the Reader ID and Firmware Version code (see below). Verify the modem is connected to the host and the Blue LED is on. (Note: Verify reader contains a radio by locating the ‘XXXX’ number - see Sec- tion 4.7. If there is no number indicated, the reader does not contain a radio.)
Prepare the reader to communicate in ‘RF Comm Mode’ by scanning the QuickConnect code on the paired modem to which you wish to establish a permanent link. Listen for the single beep to verify the connection acknowledgement. Scan the Lockout Link Mode code (see below). Set appropriate timeout settings, if applicable (see Section 1.6.5).
To reassign a permanent connection to a different reader, scan the disconnect code or disconnect power to the linked reader. Using the ‘new’ reader’ follow the directions outlined in the previous paragraph.
To remove Lockout Link Mode between reader and modem simply scan the Unlock Link Mode code (see following) with the linked reader.
Reader ID and |
|
|
Firmware Version | Lockout Link Mode | Unlock Link Mode |
Save Settings | C002332_09_CR3 User Manual - 49 |
|
|