Citizen CBM-270 user manual Paper Near End Function, Off

CBM-270 User’s Manual

4.8Paper Near End Function

If the paper is running out, the PNE sensor informs the host computer that the paper is running out, by means of a signal output or the PAPER lamp on the panel. The PAPER lamp is illuminated unconditionally.

1.If the PNE sensor detects that the paper is running out, the PAPER lamp will be illuminated.

2.If PNE is enabled, the parallel interface will output PE. (At initial setting)

3. Printing is allowed up to about 1.5 m. (Initial value) After printing or feeding the paper by a specified amount, the parallel interface will output BUSY and FAULT, and serial interface will output DTR to stop printing, respectively.

4.Replace the paper according to the procedure in "4.3 Inserting the Paper."

5.After replacing the paper, cancel the BUSY (DTR), FAULT, and PE outputs.

(1)The following lists the outputs made by the near paper end function and the paper end function. The output state can be changed by the DIP switch or a command.

DS1-1	PNE	PE Signal Output	PE Output			BUSY (DTR)/	PAPER
State	Function	Setting by Command				FAULT Output	Lamp
OFF	Disabled	*When PE is selected	*When PE is detected			*When PE is detected	*At PNE
		When PNE is selected	When PNE is detected			When PE is detected	At PNE
		When PE is selected	When PE is detected			When printing stops	At PNE
ON	Enabled					due to PNE
		*When PNE is selected	*When	PNE	is	*When printing stops	*At PNE
			detected			due to PNE

*Mark : Default setting

PNE : Paper Near End PE : Paper End

(2)Print amount after detecting PNE

When PNE is enabled, a printable amount after PNE detection can be adjusted. PNE is detected when the remaining amount of the paper roll is about 2~3 m. (It depends on the paper quality used, paper thickness, and operating environment.)

An initial value is 1.5 m. Up to 1.5 m can be printed after detecting PNE. At this time, with the approx. 70mm-thick recommended paper, the remaining amount of the paper will be about 0.5~1.5 m when printing stops.

It can be adjusted between 0 and 2.55 m with a command. Adjust it depending on the operating environment and paper quality.

Depending on an adjustment value, paper end may be detected (Printing stop) first.

If PNE is detected at power-on, a set amount of printing will be done from that point. (The default is 1.5 m)

28 CITIZEN