Citizen CBM-270 user manual ESC n, ESC t

CBM-270 User’s Manual

ESC n	n
[Function]	Setting a remaining amount of printout
[Code]	<1B>H<6E>H<n>
[Range]	0 £ n £ 255 ("n" in the 2nd byte denotes this command)
[Outline]	This command sets a print remaining amount after detecting PNE. n is set in
	units of cm.
[Caution]	If the paper near end sensor is disabled, this command will not function. The set
	value and print remaining amount are not cleared by the ESC @ command. If a
	value lower than the already set value is set at PNE detection time, the printer
	may stop printing. The set value remains valid until it is re-set or the printer is
	turned on again.
[Default]	n = 150 (Remaining amount: 150 cm)
[Sample Program]
	LPRINT CHR$(&H1B);"n";CHR$(100); ·······When setting the print remaining amount = 100 cm

ESC t	n
[Function]		Selecting the character code table
[Code]		<1B> H <74> H <n>
[Range]	0 £ n £ 1
[Outline]		Selecting Page n on the character code table:
		The character code table is selected depending on the value of n.
		"n" means the followings.
		n	Condition

0Page 0(IBM Character #2)

1Page 1(Domestic Character)

[Caution]	International character can not be changed.
	Setting condition can be confirmed by self printing
[Default]	An initial value of n is set to 1(Page 1) when the J1~3 are opened,
	the other cases, it is set to 0(Page 0).
[See Also]	Character Code Table, ESC R
[Sample Program]		[Print Results]

FOR N=0 TO 1

LPRINT CHR$ (&H1B) ; "t"; CHR$ (N) ;

LPRINT " n= " ; STR$(N) ; " " ;

FOR C=&HB1 TO &HB5

LPRINT CHR$ (C) ;

NEXT C

LPRINT CHR$ (&HA) ;

NEXT N

END

66 CITIZEN