Citizen CBM-270 user manual ESC c Parallel Interface Only

CBM-270 User’s Manual

ESC c	3 n			(Parallel Interface Only)
[Function]		Selecting the paper near end sensor valid for a paper end signal output
[Code]		<1B>H<63>H<33>H<n>
[Range]		0 £ n £255
[Outline]		This command selects at which paper near end sensor a paper end signal should
		be output. Each bit for n has the following meaning:
		Bit	Position		Value
				0		1
		0	Paper near end	Disabled		Enabled
		1~7	Undefined
		This printer can only select one kind of paper end detection, a paper-near-end
		sensor. n is valid for the least significant bit (n0).
[Caution]		This command is valid only for the parallel interface.
[Default]		A default of n is what has been set with the DIP switch (DS1-1).
[Sample Program]
		LPRINT CHR$(&H1B);"c3";CHR$(0);
		·······When outputting the paper-end signal at the paper end
		LPRINT CHR$(&H1B);"c3";CHR$(1);
		·······When outputting the paper-end signal at the paper near end

ESC c	4 n
[Function]		Selecting the paper near end sensor valid for print stop
[Code]		<1B>H<63>H<34>H<n>
[Range]		0 £ n £ 255
[Outline]		This command selects at which paper near end sensor printing should be stopped.
		Each bit for n has the following meaning:
		Bit	Position		Value
				0		1
		0	Paper near end	Disabled		Enabled
		1~7	Undefined
		This printer can only select one kind of paper-end detection, a paper-near-end
		sensor. n is valid for the least significant bit (n0).
[Caution]		If print stop is enabled, the printer will print (Feed the paper) 150 cm or an
		amount of data specified with the ESC n command and go off-line.
[Default]		A default of n is what has been set with the DIP switch (DS1-1).
[Sample Program]

LPRINT CHR$(&H1B);"c4";CHR$(0);

·······When stopping printing at the paper end

LPRINT CHR$(&H1B);"c4";CHR$(1);

········When stopping printing at the paper near end

64 CITIZEN