Cub Cadet EW-7416APN manual Display the Ssid name of the access point

Page 36

2-4-2-1 Wireless Site Survey

The table will list the access points nearby as the access point is set to Station mode; you can select one of the access points to associate.

Here are descriptions of every setup item:

Select

Click the radio button to select the access point.

Channel

Display to channel number of the access point.

SSID

Display the SSID name of the access point.

BSSID

Display the BSSID (MAC Address) of the access

 

point.

Encryption

Display the encryption setting of the access points.

 

If you have selected the access point with security

 

setting, you have to go to ‘2-7 Wireless Security’ to

 

set the same security with the access point you

 

want to associate.

Authentication

Display the authentication type of the access point.

Signal

The signal strength of each access point will be

 

displayed here. The signal strength is stronger, the

 

connection quality is better.

Mode

Display the wireless modes include 11b, 11b/g or

 

11b/g/n or 11n only of the access points.

Refresh

Click this button to refresh the table.

29

Image 36
Contents Page Copyright Federal Communication Commission Interference Statement Page TTE Compliance Statement T a L O G IP Address of the Wireless Access Point Chapter I Product Information Page System Requirements Page Front Panel Back Panel Chapter II System and Network Setup Connecting to wireless access point by web browser Page Page Page Page Page Windows Vista IP address setup Page Page Page Page Essid Bssid Access point mode, allows wireless clients to AP at the same time. It can use Station function to That Essid is Case Sensitive Up to four SSIDs can be set. If you want to Please Note That Essid is Case WMM Wlan MAC Page Display the Ssid name of the access point Band Only wireless clients using the wireless band Band Clients using 802.11b and 802.11g band will be Band Main Essid Page Main Ssid Page Page Her. see -7 for detailed information if Displayed here. If you don’t enable security Is, default value is Rate automatically, it’s not necessary to change Power to 100%. This will enhance security Page Page Page Page If you don’t know which one you should use Page Page WPA Radius Page Page Input username, password, re-type password Page Page It blank, however, it’s recommended to use this Page Page Page Page Page Chapter III Advanced Configuration Page Page Chapter IV Appendix Page Please check the status of A/C power Glossary Page TCP FTP Smtp POP3