| displayed here. If you don’t enable security |
| function of the access point before WPS is |
| activated, the access point will auto set the security |
| to WPA (AES) and generate a set of passphrase key |
| for WPS connection. |
| Passphrase Key: Displays the WPA passphrase |
| here, all characters will be replaced by asterisk for |
| security reason. If encryption is not set on this |
| access point, nothing will be displayed here. |
Config Mode | There are ‘Registrar’ and ‘Enrollee’ modes for the |
| WPS connection. When ‘Registrar’ is enabled, the |
| wireless clients will follow the access point’s |
| wireless settings for WPS connection. When |
| ‘Enrolle’ mode is enabled, the access point will |
| follow the wireless settings of wireless client for |
| WPS connection. |
Start PBC | Click ‘Start PBC’ to start |
| setup procedure. This access point will wait for |
| WPS requests from wireless clients for 2 minutes. |
| The ‘WLAN’ LED on the access point will be |
| steady on for 2 minutes when this access point is |
| waiting for incoming WPS request. |
Start PIN | Please input the PIN code of the wireless client |
| you via client wish to connect, and click ‘Start PIN’ |
| button. The ‘WLAN’ LED on the access point will |
| be steady on when this access point is waiting for |
| incoming WPS request. |
NOTE: When you’re using PBC type WPS setup, you must press ‘PBC’ button (hardware or software) of wireless client within 120 seconds; if you didn’t press PBC button of wireless client within this time period, please press ‘PBC’ button (hardware or software) of this access point again.
41