Cub Cadet EW-7416APN manual Chapter III Advanced Configuration

Page 71

Chapter III: Advanced Configuration

3-1 Configuration Backup and Restore

You can backup all configurations of this access point to a file, so you can make several copied of access point configuration for security reason.

To backup or restore access point configuration, please follow the following instructions:

Please click ‘Configuration Tool’ on the left of web management interface, and the following message will be displayed on your web browser:

Here are descriptions of every buttons:

Backup Settings

Press ‘Save...’ button, and you’ll be prompted to

 

download the configuration as a file, default

 

filename is ‘config.bin’, you can please save it as

 

another filename for different versions, and keep it

 

in a safe place.

Restore Settings

Press ‘Browse…’ to pick a previously-saved

 

configuration file from your computer, and then

 

click ‘Upload’ to transfer the configuration file to

 

access point. After the configuration is uploaded,

 

the access point’s configuration will be replaced by

 

the file you just uploaded.

Restore to Factory

Click this button to remove all settings you made,

Default

and restore the configuration of this access point

 

back to factory default settings.

64

Page 70 Page 72
Image 71
Page 70 Page 72
Contents Page Copyright Federal Communication Commission Interference Statement Page TTE Compliance Statement T a L O G IP Address of the Wireless Access Point Chapter I Product Information Page System Requirements Page Front Panel Back Panel Chapter II System and Network Setup Connecting to wireless access point by web browser Page Page Page Page Page Windows Vista IP address setup Page Page Page Page Essid Bssid Access point mode, allows wireless clients to AP at the same time. It can use Station function to That Essid is Case Sensitive Up to four SSIDs can be set. If you want to Please Note That Essid is Case WMM Wlan MAC Page Display the Ssid name of the access point Band Only wireless clients using the wireless band Band Clients using 802.11b and 802.11g band will be Band Main Essid Page Main Ssid Page Page Her. see -7 for detailed information if Displayed here. If you don’t enable security Is, default value is Rate automatically, it’s not necessary to change Power to 100%. This will enhance security Page Page Page Page If you don’t know which one you should use Page Page WPA Radius Page Page Input username, password, re-type password Page Page It blank, however, it’s recommended to use this Page Page Page Page Page Chapter III Advanced Configuration Page Page Chapter IV Appendix Page Please check the status of A/C power Glossary Page TCP FTP Smtp POP3
Top Page Image Contents