Cub Cadet EW-7416APN manual

Page 53

There are four types of security level you can select: Disable (no security

-data encryption disabled), WEP, WPA Pre-shared Key, and WPA Radius. Please refer to the following sections for detailed instructions.

NOTE: If you have enabled Multiple SSID function, please select the SSID network you wish to configure in advance.

Please remember it’s very important to set wireless security settings properly! Without a proper setting, hackers and intruders may gain access to your local network and do something bad to your computers and servers, which could cause serious problem.

There are several things you can do to improve wireless security:

1.Always enable data encryption. Only disable it when you want to open your wireless access point to the public.

2.Never use simple words as encryption password. Use the random combination of symbols, numbers, and alphabets will greatly improve security.

3.Use WPA when possible - it's much safer than WEP.

4.Change encryption password when you’ve used it for too long time.

46

Image 53
Contents Page Copyright Federal Communication Commission Interference Statement Page TTE Compliance Statement T a L O G IP Address of the Wireless Access Point Chapter I Product Information Page System Requirements Page Front Panel Back Panel Chapter II System and Network Setup Connecting to wireless access point by web browser Page Page Page Page Page Windows Vista IP address setup Page Page Page Page Essid Bssid Access point mode, allows wireless clients to AP at the same time. It can use Station function to That Essid is Case Sensitive Up to four SSIDs can be set. If you want to Please Note That Essid is Case WMM Wlan MAC Page Display the Ssid name of the access point Band Only wireless clients using the wireless band Band Clients using 802.11b and 802.11g band will be Band Main Essid Page Main Ssid Page Page Her. see -7 for detailed information if Displayed here. If you don’t enable security Is, default value is Rate automatically, it’s not necessary to change Power to 100%. This will enhance security Page Page Page Page If you don’t know which one you should use Page Page WPA Radius Page Page Input username, password, re-type password Page Page It blank, however, it’s recommended to use this Page Page Page Page Page Chapter III Advanced Configuration Page Page Chapter IV Appendix Page Please check the status of A/C power Glossary Page TCP FTP Smtp POP3