Cub Cadet EW-7416APN manual

Page 69

2-10-3 DHCP Server

This wireless access point is capable to act as a DHCP server for your network, and it’s disabled by default. If you want to activate this function, please click ‘System Utility’ on the left, and the following message will be displayed:

NOTE: Please remember to select ‘Enable’ in ‘DHCP Server’ option as described in last Section or all DHCP-related fields will be grayed out, and you will not be able to input any DHCP parameter.

Here are descriptions of every setup item:

Default Gateway	Please input the IP address of default gateway of
IP	your network here.
Domain Name	Please input the IP address of domain name server
Server IP	(DNS) here.
Start IP	Please input the start IP address of the IP range.
End IP	Please input the end IP address of the IP range.
Domain Name	If you wish, you can also optionally input the
	domain name for your network. This is optional.
Lease Time	Please choose a lease time (the duration that every
	computer can keep a specific IP address) of every
	IP address assigned by this access point from
	dropdown menu.

After you finish, please click ‘Apply’, and the following message will be

62

Image 69

Contents Page Copyright Federal Communication Commission Interference Statement Page TTE Compliance Statement T a L O G IP Address of the Wireless Access Point Chapter I Product Information Page System Requirements Page Front Panel Back Panel Chapter II System and Network Setup Connecting to wireless access point by web browser Page Page Page Page Page Windows Vista IP address setup Page Page Page Page Essid Bssid Access point mode, allows wireless clients to AP at the same time. It can use Station function to That Essid is Case Sensitive Up to four SSIDs can be set. If you want to Please Note That Essid is Case WMM Wlan MAC Page Display the Ssid name of the access point Band Only wireless clients using the wireless band Band Clients using 802.11b and 802.11g band will be Band Main Essid Page Main Ssid Page Page Her. see -7 for detailed information if Displayed here. If you don’t enable security Is, default value is Rate automatically, it’s not necessary to change Power to 100%. This will enhance security Page Page Page Page If you don’t know which one you should use Page Page WPA Radius Page Page Input username, password, re-type password Page Page It blank, however, it’s recommended to use this Page Page Page Page Page Chapter III Advanced Configuration Page Page Chapter IV Appendix Page Please check the status of A/C power Glossary Page TCP FTP Smtp POP3