Cub Cadet EW-7416APN manual Clients using 802.11b and 802.11g band will be

Page 40

	clients using 802.11b and 802.11g band will be
	able to connect to this access point.
	If you want to allow 802.11b, 802.11g, and 802.11
	Draft-N clients to connect to this access point,
	select 2.4GHz (B+G+N).
Channel Number	Please select a channel number you wish to use.
	The channel number must be same with another
	wireless access point you wish to connect
MAC address 1-4	Please input the MAC address of the wireless
	access point you wish to connect
Set Security	Click this button to select an encryption mode for
	this wireless link, a new popup window will
	appear. Please refer to Section 2-7 for detailed
	descriptions.

After you finish with setting, please click ‘Apply’, and the following message will be displayed:

When you see this message, the settings you made is successfully save. You can click ‘Continue’ button to back to previous page and continue on other setting items, or click ‘Apply’ button to restart the wireless access point and the changes will take effect after about 30 seconds.

33

Image 40

Contents Page Copyright Federal Communication Commission Interference Statement Page TTE Compliance Statement T a L O G IP Address of the Wireless Access Point Chapter I Product Information Page System Requirements Page Front Panel Back Panel Chapter II System and Network Setup Connecting to wireless access point by web browser Page Page Page Page Page Windows Vista IP address setup Page Page Page Page Essid Bssid Access point mode, allows wireless clients to AP at the same time. It can use Station function to That Essid is Case Sensitive Up to four SSIDs can be set. If you want to Please Note That Essid is Case WMM Wlan MAC Page Display the Ssid name of the access point Band Only wireless clients using the wireless band Band Clients using 802.11b and 802.11g band will be Band Main Essid Page Main Ssid Page Page Her. see -7 for detailed information if Displayed here. If you don’t enable security Is, default value is Rate automatically, it’s not necessary to change Power to 100%. This will enhance security Page Page Page Page If you don’t know which one you should use Page Page WPA Radius Page Page Input username, password, re-type password Page Page It blank, however, it’s recommended to use this Page Page Page Page Page Chapter III Advanced Configuration Page Page Chapter IV Appendix Page Please check the status of A/C power Glossary Page TCP FTP Smtp POP3