Cub Cadet EW-7416APN manual Federal Communication Commission Interference Statement

Page 3

Federal Communication Commission

Interference Statement

FCC Part 15

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Reorient or relocate the receiving antenna.

2.Increase the separation between the equipment and receiver.

3.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4.Consult the dealer or an experienced radio technician for help.

FCC Caution

This equipment must be installed and operated in accordance with provided instructions and a minimum 20 cm spacing must be provided between computer mounted antenna and person’s body (excluding extremities of hands, wrist and feet) during wireless modes of operation.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Image 3
Contents Page Copyright Federal Communication Commission Interference Statement Page TTE Compliance Statement T a L O G IP Address of the Wireless Access Point Chapter I Product Information Page System Requirements Page Front Panel Back Panel Chapter II System and Network Setup Connecting to wireless access point by web browser Page Page Page Page Page Windows Vista IP address setup Page Page Page Page Essid Bssid Access point mode, allows wireless clients to AP at the same time. It can use Station function to That Essid is Case Sensitive Up to four SSIDs can be set. If you want to Please Note That Essid is Case WMM Wlan MAC Page Display the Ssid name of the access point Band Only wireless clients using the wireless band Band Clients using 802.11b and 802.11g band will be Band Main Essid Page Main Ssid Page Page Her. see -7 for detailed information if Displayed here. If you don’t enable security Is, default value is Rate automatically, it’s not necessary to change Power to 100%. This will enhance security Page Page Page Page If you don’t know which one you should use Page Page WPA Radius Page Page Input username, password, re-type password Page Page It blank, however, it’s recommended to use this Page Page Page Page Page Chapter III Advanced Configuration Page Page Chapter IV Appendix Page Please check the status of A/C power Glossary Page TCP FTP Smtp POP3