Delta Tau 4Ax-602804-xHxx manual Firmware Updates, Make sure to power down the Macro Station

Page 24

MACRO-CPU Hardware Reference

FIRMWARE UPDATES

Downloading new firmware to the MACRO Station is a simple process once the MACRO board is setup properly. To download new firmware to the MACRO station, the user must have the following items:

5V power supply

2 jumpers

DB9 female to 10 pin header (any cable used for PMAC RS232 communications) PC at the DOS prompt.

New firmware and necessary downloading batch files

Make sure to power down the MACRO Station

To download the software to the MACRO station, the user will first jumper the following E2 (1-2) and E1 (1-2). Wire the 5V power to the appropriate terminal on the MACRO station or plug into 3U Rack.

Place the 10 pin header cable to the serial connection on the MACRO-station and place the other end to the COM1 port on the PC (the batch files were written for COM1 but could be modified if necessary).

Goto the DOS prompt and create a directory called firmware and station (as an example). C:\firmware\station

a:\copy *.* c:\firmware\station

Go back to the c drive and type the following command c:\firmware\station\mcdwnld

The firmware will be down loaded to the MACRO station. Easy!

The PMAC Executive Software will soon have the capability of downloading the MACRO Station firmware in the Windows Operating Environment.

(5)Place jumper E2 back to pins 2-3 and remove E1 jumper

Please call the factory if you have any questions.

20	Firmware Updates

Image 24

Contents Macro CPU Board Page Contents MACRO-CPU Hardware Memory MAP Introduction 3U Macro CPU3U Product Configurations General Description Umac Macro Station Configuration Axis Stack ConfigurationUmac and 3U-Stack Products Umac Products Umac MacroMacro CPU Specifications Physical SpecificationsElectrical Specifications 3U MACRO-CPU Configuration MACRO-CPU Hardware Reference 3U MACRO-CPU Configuration 3U Macro CPU Board Hardware Setup 3U Macro CPU Board Jumper & Switch SetupWhich Stack Axis Backplane Umac Axis SW1 Setting Macro CPU Board Connections MACRO-CPU Hardware Reference Page 3U MACRO-CPU Jumper and Switch Configurations 3U MACRO-CPU Card LayoutE1 Watchdog Timer Disable E2 CPU Mode OperationE4 Power Supply-Loss Control ±15Vdc Supply Monitor E3 Serial Port Baud RateE40 Macro Input Fiber/Wired Selector JP4 Reserved for Future UseThis jumper does not exist on MACRO-CPU versions Earlier This jumper does not exist on MACRO-CPU versions GreaterJP5-JP6 Macro Copper EQ Select rev -104 and earlier Switch Configurations SW1 Macro Slave Node ConfigureSW2 Macro Master Number Select Connector Summary J14, J17TB1 U73Macro Station Character Display Hardware RE-INITIALIZATION MACRO-CPU Hardware Reference Hardware Re-initialization Firmware Updates Make sure to power down the Macro StationMACRO-CPU Hardware Reference Firmware Updates 3U MACRO-CPU Board Connector PIN-OUTS J6 Jthw Multiplexer Port ConnectorPin # Symbol Front ViewCircuitry For J6- Jthw Interface J7 JRS232 Serial Port Connector Pin RJ45 Front View Pin # Symbol Function Description DATA+Data P1 Ubus Interface Connector U73 Macro Fiber Optic Connector OPT a Location B-4 Pin # Symbol Function DescriptionTB1 Jpwr 4-Pin Terminal Block MACRO-CPU Hardware Memory MAP Reference Addr hex DescriptionMACRO-CPU Hardware Reference MACRO-CPU Hardware Memory Map Accessories ACC-55E, UnetACC-53E, SSI Amplifiers Analog