Matsushita CF-Y5LWVYZ 1 2 service manual Removing the Drive Unit, Removing the Main Board, Gadket

9.2.10. Removing the Drive Unit

Preparation : perform the section 9.2.1., 9.2.3. and 9.2.4. first.

1.Peel off the tape from the connector.

2.DVD FFC is removed from connector (CN501), and the drive unit is lifted from the bottom case, and the gasket is peeled off and then remove the drive unit.

Tape

CN501

Drive Unit	Gadket
Note:	DRIVE-MAIN FFC

-When you exchange DRIVE-MAIN FFC,

mark the bottom case, and match new FFC to marking of the bottom case, bend, and build the bend externals of FFC before peeling off FFC from the bottom case.

-Tape and gusket cannot be recycled. Please use new parts.

9.2.11. Removing the Main Board

Preparation : perform the section 9.2.1., 9.2.3. and 9.2.4. first.

1.Remove the 2 screws (S), 2 screws (T) and 1 screw (U).

Screw (S) : K1YE5000022 (N15)

Screw (T) : DFHE5035ZB (N1)

Screw (U) : DXQT2+E6FNL (N10)

2.Peel off the 6 tapes, main PWB sheet and line hold sheet 3.

Main PWB sheet : DFMX1228ZA (K64)

Line hold sheet 3 : DFHR3D59YA (K47)

Screw (U)

Main PWB Sheet

Screw (T)

3.Disconnect the LCD connector (CN9) (CN10), DC-IN connector (CN601) and FFC (CN4) (CN6) (CN18) (CN8).

DC-IN		MODEM LAN
Cable	LCD Cable	Holder
		MODEM
	HDD FFC	Cable

FFC Drive

LAN Cable

USB FPC

4.Turn inside out the main board. Remove the antenna cable (L ), (R) from the wireless LAN module, and then remove the main board.

5.Remove the connector from CN3 and then remove the coin battery.

Antenna Cable

(L)

	Antenna Board
	(L)
Antenna Cable
(R)	Antenna Board
Coin Battery
	(R)

Screw (S)

Tape

Tape

Tape

Line Hold Sheet 3

30