Matsushita CF-Y5LWVYZ 1 2 Putting LCD Magnet, Putting LCD Cushion / Assembly of the Inverter

9.3.2.4. Putting LCD Magnet

(Attention)

-The LCD Front is installed in the receiving stand, and works.

Refer to A chart.

The both sides tape flak- ing off paper is peeled off, and affixes to Front Case

When inserting in the Front Case, it is noted not to roll the cushion

The both sides tape flak- ing off paper is peeled off, and affixes to Front Case

When inserting in the

Front Case, it is noted

not to roll the cushion

The both sides tape flaking off paper is peeled off, and affixes to Front Case

The LCD Magnet is affixed to the dotted line part.(Affix on the plate side)

LCD Magnet

LCD

Safety Work

Fit to inside surface.

Paste side

Affixes between ribs

Pressurize it from the Front Case side (painting side) when you pressurize a two sided tape

9.3.2.5. Putting LCD Cushion / Assembly of the Inverter

Use the treatment device when you affix the LCD magnet

Division attention for XGA (There is marking)

(Attention)
-The LCD Front is installed in the receiving stand, and works.
	0-3mm
LCD Cushion 2		0 1mm
LCD Cushion 3

LCD Cushions

Paste side

Paste side

LCD Cushion 1

Paste side

Affixes to the length wall side.

Rib

Paste side

There is no space.

LCD

<Affixation OK figure>

LCD Cushions

LCD Cushion 2

Safety Work

Do not bend, do not twist, and do not add the impact when you handle Inverter.

There is a space.

LCD

Paste side

			P	aste	side
									Pink	Safety important parts
										Inverter Board
		2-5mm
0 1mm								Connection
											After affixing
	Rib										the PET Tape
							<Affixation standard of PET Tape>
						Safety Work
							Standard of match affixation
							of connector externals
							(0 1mm)

<Affixation NG figure>

Safety Work	Affixes in a connector
	externals putting to-
PET Tape
	gether.(wrapping)

37