Minuteman UPS SNMP-32 Series user manual Set Snmp MIB System, Set Snmp Access Control, Set Email

Page 22

4. Telnet Main Menu screen (Fig. 32).

Fig. 32-Telnet: Main Menu

•Set IP Address

This function is for setting the IP Address, the Gateway Address, and the Subnet Mask.

•Set SNMP MIB System

This function is for setting the MIB System Group parameters.

•Set SNMP Access Control

This function is for setting the IP Manager, the Community String, and the Access Permission.

Note: The configuration of ‘Set SNMP Access Control’ is only used for SNMP Network Manager.

•Set SNMP Trap Notification

If you want to use a PC and perform the ‘Trap’ function of the SNMP manager to manage the RPM through SNMP-32 card, the IP address of the PC must be added in this list of SNMP-32 card.

Note: The configuration of ‘Set SNMP Trap Receiver’ is only used for SNMP Network Manager.

•Set System Time & Time Server

This function is for setting the System Date, and the System Time.

•Set Web and Telnet User Account

This function is for setting the user’s account authorization.

•Set Email

This function is for setting the email accounts to receive power event notification.

•Reset Configuration to Default

This function is for setting all values to their default settings.

•Save & Reboot

This function is for saving the current configuration (including any/all changes that were made) and then rebooting the SNMP-32 card.

•Exit Without Saving

This function is for exiting the configuration setup without saving any/all changes that were made.

22

Image 22

Contents SNMP-32 Series Table of Contents Trademarks Conventions used in this guideFeatures IntroductionPackage Contents Applications Internal SNMP-32 card Installation ProcedureExternal SNMP-32 card SNMP-32L Only Setup-Procedure Snmp Utility GroupSnmp Utility Set IP address for SNMP-32 card Web Management Interface Main MenuConfiguration Network Information System StatusSecondary DNS Server IP Configuration SnmpAccess Control Ethernet Connection TypeTrap Notification Snmp ScreenRecipient’s Email Address for Event Log Configuration EmailEmail Setting Recipient’s Email Address for Daily ReportConfiguration Web/Telnet Configuration PPPUser Account Configuration System Time Log Information EventCPS Event List ENV Event ListATS Event List Log Information Data Data LogFirmware Upgrade Procedure Snmp Utility Download Firmware Telnet Configuration TelnetSave & Reboot Set Snmp Access ControlReset Configuration to Default Set Snmp MIB SystemConnected Device Uninterruptible Power Supply UPSBattery Information UPS InformationInput Status Battery StatusUPS Status Output StatusCancel Test Quick Battery TestDeep Battery Calibration Shutdown UPS Battery mode onlyGraphic View Graphic View ScreenUPS Recorded UPS SettingsUPS Properties Test UPSNew Schedule Event Screen RPM Action Remote Power Manager RPM Power Resume Delay RPM Setting Fig Select RPMPower off Delay Address ChangeRPM Schedule RPM Schedule ScreenCPS Status Fig Current Probe Sensor CPSThreshold Temp/Hum32-Probe ENV ENV Status FigInput Power Source B Automatic Transfer Switch ATSInput Power Source a ATS Status FigConfiguring the NMS General Network Management StationsGateways AppendixCommunities IP AddressesSubnet Mask Routing and Filtering Troubleshooting ProblemObtaining Technical Assistance Installation SiteWhat are the symptoms? If you are a consultantLimited Product Warranty Limited Product Warranty