Minuteman UPS SNMP-32 Series user manual UPS Settings, UPS Properties, UPS Recorded, Test UPS

Page 27

5.UPS Settings

This screen is for the user to input information about the UPS (Fig. 39).

UPS Properties

The user can input the date of the last time the battery was replaced.

UPS Recorded

The user can set the time interval to log UPS Data.

Test UPS

The user can set the time interval for the UPS to perform a test.

Warning Threshold Value

Time Out of Connection Lost: The user can set the time interval for a warning of a lost connection.

Critical Loading: The user can set the warning threshold for an Overload condition.

Fig. 39-UPS Settings Screen

6.UPS Schedule

This screen allows the user to schedule a shutdown and a restart of the UPS (Fig. 40). To add a new schedule, select the “New” button. To make changes to a current schedule, select [Edit]. To remove a schedule, select [Delete].

Fig. 40-UPS Schedule Screen

27

Image 27

Contents SNMP-32 Series Table of Contents Conventions used in this guide TrademarksIntroduction FeaturesPackage Contents Applications Installation Procedure Internal SNMP-32 cardExternal SNMP-32 card SNMP-32L Only Snmp Utility Group Setup-ProcedureSnmp Utility Set IP address for SNMP-32 card Main Menu Web Management InterfaceInformation System Status Configuration NetworkEthernet Connection Type Configuration SnmpAccess Control Secondary DNS Server IPSnmp Screen Trap NotificationRecipient’s Email Address for Daily Report Configuration EmailEmail Setting Recipient’s Email Address for Event LogConfiguration PPP Configuration Web/TelnetUser Account Log Information Event Configuration System TimeENV Event List CPS Event ListATS Event List Data Log Log Information DataFirmware Upgrade Procedure Snmp Utility Download Firmware Telnet Telnet ConfigurationSet Snmp MIB System Set Snmp Access ControlReset Configuration to Default Save & RebootUPS Information Uninterruptible Power Supply UPSBattery Information Connected DeviceOutput Status Battery StatusUPS Status Input StatusShutdown UPS Battery mode only Quick Battery TestDeep Battery Calibration Cancel TestGraphic View Screen Graphic ViewTest UPS UPS SettingsUPS Properties UPS RecordedNew Schedule Event Screen RPM Action Remote Power Manager RPM Address Change RPM Setting Fig Select RPMPower off Delay Power Resume DelayRPM Schedule Screen RPM ScheduleCurrent Probe Sensor CPS CPS Status FigThreshold ENV Status Fig Temp/Hum32-Probe ENVATS Status Fig Automatic Transfer Switch ATSInput Power Source a Input Power Source BGeneral Network Management Stations Configuring the NMSIP Addresses AppendixCommunities GatewaysSubnet Mask Routing and Filtering Problem TroubleshootingIf you are a consultant Installation SiteWhat are the symptoms? Obtaining Technical AssistanceLimited Product Warranty Limited Product Warranty