Minuteman UPS SNMP-32 Series UPS Control, Quick Battery Test, General System Test, Cancel Test

Page 25

3.UPS Control

This screen is to provide remote UPS test functions (Fig. 35). Choose the test item and click on 'Apply' to execute the test.

Quick Battery Test

The Quick Battery Test function will test the battery for 5-seconds.

General System Test

The General System Test function will test the UPS and the battery for-15 seconds. This test can only be performed when the battery is fully charged.

Deep Battery Calibration

The Deep Battery Calibration function will test the UPS and the Battery until Low Battery Warning (LBW). When this test is performed, the UPS will switch to the battery mode and operate until the Low Battery Warning alarm occurs. Then the UPS will switch back to the normal AC mode.

Cancel Test

The Cancel Test function is to abort a test while the test is in progress.

Shutdown UPS (Battery mode only)

Selecting 'Shutdown UPS' will turn off the UPS. This function can only be performed in the battery mode. The UPS will automatically restart when AC returns.

Put UPS in Sleep mode for XX minutes

When the UPS is in the Sleep mode, it will not provide power to the outlets. The UPS will restart once the Sleep mode function is complete.

Cancel Shutdown

The Cancel Shutdown function is to abort a shutdown while a shutdown is in progress.

Audible alarm

•Disabled: Turn off the audible alarm.

•Enabled: Turn on the audible alarm.

•Muted: Mute the audible alarm until an event occurs (Fault, LBW).

•Disabled Until Low Battery Warning: Turn off the audible until a Low Battery Warning occurs.

Fig. 35-UPS Control Screen

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents SNMP-32 Series Table of Contents Conventions used in this guide TrademarksIntroduction FeaturesPackage Contents Applications Internal SNMP-32 card Installation ProcedureExternal SNMP-32 card SNMP-32L Only Snmp Utility Group Setup-ProcedureSnmp Utility Set IP address for SNMP-32 card Main Menu Web Management InterfaceInformation System Status Configuration NetworkAccess Control Configuration SnmpSecondary DNS Server IP Ethernet Connection TypeSnmp Screen Trap NotificationEmail Setting Configuration EmailRecipient’s Email Address for Event Log Recipient’s Email Address for Daily ReportConfiguration Web/Telnet Configuration PPPUser Account Log Information Event Configuration System TimeCPS Event List ENV Event ListATS Event List Data Log Log Information DataFirmware Upgrade Procedure Snmp Utility Download Firmware Telnet Telnet ConfigurationReset Configuration to Default Set Snmp Access ControlSave & Reboot Set Snmp MIB SystemBattery Information Uninterruptible Power Supply UPSConnected Device UPS InformationUPS Status Battery StatusInput Status Output StatusDeep Battery Calibration Quick Battery TestCancel Test Shutdown UPS Battery mode onlyGraphic View Screen Graphic ViewUPS Properties UPS SettingsUPS Recorded Test UPSNew Schedule Event Screen RPM Action Remote Power Manager RPM Power off Delay RPM Setting Fig Select RPMPower Resume Delay Address ChangeRPM Schedule Screen RPM ScheduleCPS Status Fig Current Probe Sensor CPSThreshold ENV Status Fig Temp/Hum32-Probe ENVInput Power Source a Automatic Transfer Switch ATSInput Power Source B ATS Status FigGeneral Network Management Stations Configuring the NMSCommunities AppendixGateways IP AddressesSubnet Mask Routing and Filtering Problem TroubleshootingWhat are the symptoms? Installation SiteObtaining Technical Assistance If you are a consultantLimited Product Warranty Limited Product Warranty
Top Page Image Contents