Minuteman UPS SNMP-32 Series user manual Setup-Procedure, Snmp Utility Group

3.Setup-Procedure

This section will guide you through the Setup-Procedure of the SNMP-32 Card.

NOTE: The minimum requirement to operate the SNMP-32 Card is to setup the IP Address. The SNMP Utility supports most Windows Operating Systems (98, 2000, XP).

1.Load the SNMP Utility CD into the CD-ROM drive, and then open the ‘Install SNMP Utility’.

2.Once the installation is complete, there will be a ‘SNMP Utility’ group in the Windows ’Start’ ￿‘Program Group’.

3.Click the “SNMP Utility” to initiate the SNMP Utility program (Fig. 5).

Fig. 5-SNMP Utility Group

4.Once the SNMP Utility is open, the SNMP Utility will search for the network adapter automatically, or, click on Network Selection from the main page. The screen will display the network adapter that was located. Click on the network adapter, and then press “OK” to return to the main page of SNMP Utility (Fig. 6).

Fig. 6-SNMP Utility: Network Selection

5.The SNMP Utility will then search for and display all of the SNMP-32 cards that are on your LAN. Select the appropriate SNMP-32 card on the right side of the screen, and then click “Configure” or double click on the appropriate SNMP-32 card to open the Configuration Menu (Fig. 7).

Fig. 7-SNMP Utility: Configuration Menu

8