Minuteman UPS SNMP-32 Series user manual UPS Status, Input Status, Output Status, Battery Status

Page 24

2.UPS Status

This screen shows the UPS’s current status (Fig. 34). The users can choose a time interval from the drop-down box to refresh the status information.

UPS Status

This section is to show the UPS power status. The abnormal status will be displayed (in red) when there is an abnormal power event.

Input Status

This section is to show the UPS input status (AC Status/Input Voltage/Input Frequency). The values will be shown in red when an abnormal condition occurs.

Output Status

This section is to show the UPS output status (Output Voltage/Output Status/UPS Loading). The values will be shown in red when an abnormal condition occurs.

Battery Status

This section is to show the UPS Battery Status (Temperature/Battery Status/Battery Capacity/Battery Voltage/Time on Battery). The values will be shown in red when an abnormal condition occurs.

Fig. 34-UPS Status Screen

24

Image 24

Contents SNMP-32 Series Table of Contents Trademarks Conventions used in this guideFeatures IntroductionPackage Contents Applications Installation Procedure Internal SNMP-32 cardExternal SNMP-32 card SNMP-32L Only Setup-Procedure Snmp Utility GroupSnmp Utility Set IP address for SNMP-32 card Web Management Interface Main MenuConfiguration Network Information System StatusConfiguration Snmp Access ControlSecondary DNS Server IP Ethernet Connection TypeTrap Notification Snmp ScreenConfiguration Email Email SettingRecipient’s Email Address for Event Log Recipient’s Email Address for Daily ReportConfiguration PPP Configuration Web/TelnetUser Account Configuration System Time Log Information EventENV Event List CPS Event ListATS Event List Log Information Data Data LogFirmware Upgrade Procedure Snmp Utility Download Firmware Telnet Configuration TelnetSet Snmp Access Control Reset Configuration to DefaultSave & Reboot Set Snmp MIB SystemUninterruptible Power Supply UPS Battery InformationConnected Device UPS InformationBattery Status UPS StatusInput Status Output StatusQuick Battery Test Deep Battery CalibrationCancel Test Shutdown UPS Battery mode onlyGraphic View Graphic View ScreenUPS Settings UPS PropertiesUPS Recorded Test UPSNew Schedule Event Screen RPM Action Remote Power Manager RPM RPM Setting Fig Select RPM Power off DelayPower Resume Delay Address ChangeRPM Schedule RPM Schedule ScreenCurrent Probe Sensor CPS CPS Status FigThreshold Temp/Hum32-Probe ENV ENV Status FigAutomatic Transfer Switch ATS Input Power Source aInput Power Source B ATS Status FigConfiguring the NMS General Network Management StationsAppendix CommunitiesGateways IP AddressesSubnet Mask Routing and Filtering Troubleshooting ProblemInstallation Site What are the symptoms?Obtaining Technical Assistance If you are a consultantLimited Product Warranty Limited Product Warranty