Chapter 2 Configuring The Validator
Requesting A Validator Report
This procedure prints a summarized validator report on the printer itself.
.
1. Press ..
to take the printer offline and place the printer in Menu mode.
2. If necessary, press ↓ and ↵ at the same time to unlock the ↵ key.
.
3. If necessary, press ..
until “VALIDATOR” displays.
4. Press ↓ until “Validator Report” displays.
5. Press ↵ to print the report.
6. Press ↓ and ↵ at the same time to lock the ↵ key, then press PAUSE to take the printer offline.
7. Press PAUSE again to put the printer online.
Setting Auto Report
This function allows you to disable or enable an automatic validator report printout after a batch job. The factory default is Disable.
You can determine the end of a batch job in two ways:
•by using an Execute command, or
•a timeout of more than 10 seconds.
To enable Auto Report:
.
1. Press ..
to take the printer offline and place the printer in Menu mode.
2. If necessary, press ↓ and ↵ at the same time to unlock the ↵ key.
.
3. If necessary, press ..
until “VALIDATOR” displays.
4. Press ↓ until “Auto Report” displays.
5. Press + or – to scroll through the choices: Enable or Disable. The default is Disable.
6. When Enable displays, press ↵ to activate Auto Report.
7. Press ↓ and ↵ at the same time to lock the ↵ key, then press PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
44