Defining Validator Options
Setting For Skip Labels
This option is used for skipping blank labels after bad labels have been marked. It is useful when you want to have extra blank labels in between bad and good ones. The settings are Minimum (the default) and Maximum. Minimum allows one blank label, and Maximum allows two blank labels.
NOTE: Minimum and Maximum blank labels are only applicable for forms 2 inches (5.08 cm) high or more. For labels less than 2 inches high, the minimum and maximum blank labels may vary.
.
1. Press ..
to take the printer offline and place the printer in Menu mode.
2. If necessary, press ↓ and ↵ at the same time to unlock the ↵ key.
.
3. If necessary, press ..
until “VALIDATOR” displays.
4. Press ↓ until “Skip Labels” displays.
5. Press + or – to scroll through the choices: Minimum or Maximum. The default is Minimum.
6. Press ↵ to select the desired value.
7. Press ↓ and ↵ at the same time to lock the ↵ key, then press PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
Setting Overstrike Style
This option is used for marking bad labels with different overstrike styles: Grid, Grey, Checkerboard, or Error Type Msg.
.
1. Press ..
to take the printer offline and place the printer in Menu mode.
2. If necessary, press ↓ and ↵ at the same time to unlock the ↵ key.
.
3. If necessary, press ..
until “VALIDATOR” displays.
4. Press ↓ until “Overstrike Style” displays.
5. Press + or – to scroll through the choices: Grid, Grey, Checkerboard, or Error Type Msg. The default is Grid.
51