Printronix T5000e Series user manual Error Messages Message List Explanation Solution

		Error Messages
	Table 4. Message List
Message	Explanation	Solution
Bar code quiet	Data validation error: the	1. Fix the application.
zone too small	blank zone(s) left or right of	2. Disable Quiet Zone in
	the bar code is not big
		the VALIDATOR menu.
	enough to meet the minimum
	requirement.
	Typically, this occurs in forms
	where bar codes are placed
	too close to other elements,
	the bar code is too close to an
	edge of the media, or the
	media’s position is shifting.
	The minimum quiet zone on
	each end of the bar code
	should be ten times the
	minimum element width or 1/
	4 inch, whichever is greater.
	In addition, between bar
	codes, the validator requires
	a minimum distance of 20
	times the minimum element
	width or 1/2 inch, whichever is
	greater.
Calibration	The validator has detected	Press PAUSE to clear the
warning	that it needs calibration. This	message. Calibrate the
	message is a reminder and	validator. See “Calibration”
	does not halt printing.	on page 34.
Checksum Failure	The bar code data fails the	Verify that the checksum
	checksum check or is missing	digit exists in the bar code
	the checksum digit.	and that it is the correct
		value.

65