Telstrat Argent manual Copyright 1999 Telstra Corporation Limited

Page 2

Argent Terminal Adaptor - User Guide

The information contained in this document was correct at the time of printing. However, in order to improve its products, Telstra reserves the right to modify the details in this document at any time and without warning.

Copyright© 1999 Telstra Corporation Limited

Copyright© 1999 Braintree Communications Pty Ltd

http://www.braintree.com.au

This work is copyright. All rights reserved. Other than for purposes and subject to conditions prescribed under the Copyright Act, no part of it may in any form or by any means (electronics, mechanical, photocopying, microcopying, scanning, recording or otherwise) be reproduced, stored in a retrieval system or transmitted without prior permission from Telstra Corporation Limited and Braintree Communications Pty Ltd. This document has been developed by Telstra and Braintree for the Telstra Argent Terminal Adapter.

© Registered Trademark of Telstra Corporation Limited

™ Trademark of Telstra Corporation Limited

Version 1.1	Telstra Corporation Limited
Page 2/29	ACN 051 775 556

Image 2

Contents Version Copyright 1999 Telstra Corporation Limited Table of Contents 24 Serial Port ‘AT’ Commands Introduction Description 3.1 ApplicationPackage Contents DefinitionsBack Panel Port FunctionsTop Panel Seven Segment Display Display InterpretationConnect ATA to NT1 ATA Activation InstructionsPrepare position Connect the Eftpos terminal to ATASelect the Required TEI Number Power-up the ATAAdjust the Display Orientation of the ATA Observe D-Channel X.25 Call Progress For the First CallObserve for Failure to Connect Observe for Configuration File ErrorsObserve the Software Download Observe that the ATA is ready and record the service details Replace the ATA if Faulty on ArrivalPoint-to-Point Protocol PPP Installation Click on Control PanelTick Don’t detect my modem I will select from list Installing Dial-Up Network Configuring Dial-Up Networking DUN Open Dial-Up Networking Double click on Make New ConnectionEnd to end test 17 V.120 SetupConnect the Eftpos terminal ATA Maintenance Warranty ATA out of Warranty with Telstra Service Assurance ‘AT’ Commands IntroductionRegister settings Register DescriptionPots Telephone Supplementary Features 5.1 Introduction Abbreviations used in the Pots feature descriptions RSPMalicious Call Identification Mcid / MCT Telephone Port Pots FeaturesCall Waiting CW Call Line Presentation Clip Call Forward Multiple Subscriber Number MSNOH DT #1# telephone number # RH