Telstrat Argent manual OH DT #1# telephone number # RH

Page 28

Argent Terminal Adaptor - User Guide

All voice phone calls and data calls will be answered if a telephone number is not entered into the AT command registers. Once an MSN telephone number is entered, the ATA will use this number and only receive calls received for this specific telephone number. All data calls and normal voice calls will only be recognised by the ATA if the phone number matches the number stored in the ATA. The ATA can distinguish if the remote device has sent the call as a data call or a voice call (modems / faxes attached to the POTS port are treated like voice calls). Data calls are directed to the V.24 / RS232 port and voice calls are assigned to the POTS port.

Usually calls are charged to the primary number for billing purposes. A different telephone number can be can be used for charging purposes and then calls assigned to this number would usually appear separately on the same bill. The telephone number used must be stored in the ATA and selected using an abbreviated dialling sequence at the time of dialling. This facility could be used to distinguish between business and home calls.

Equipment with Call Line Identification (CLI) capabilities will only see the primary phone number. The exchange will only pass on the primary number regardless of which number is offered to the exchange.

If an invalid phone number is stored in the ATA for the MSN feature then the exchange will assume the primary number for the phone call, but incoming calls WILL NOT be recognised by the ATA.

Setting the MSN Telephone Number from Phone Handset on the POTS port can be accomplished with by entering

a

Setting Telephone Number from Phone Handset on the POTS port. (Note 2)

OH DT #1# [telephone number] # RH

Note 2: The [telephone number] should be replaced with one of the telephone numbers assigned for your service and is not optional (eg #1#0332551234#).

The ATA’s MSN phone number can also be entered using the AT command shown in section4.2 for the register S51.

Version 1.1

Telstra Corporation Limited

Page 28/29

ACN 051 775 556

Page 27 Page 28
Image 28
Page 27 Page 28
Contents Version Copyright 1999 Telstra Corporation Limited Table of Contents 24 Serial Port ‘AT’ Commands Introduction Description 3.1 ApplicationPackage Contents DefinitionsBack Panel Port FunctionsTop Panel Seven Segment Display Display InterpretationATA Activation Instructions Prepare positionConnect ATA to NT1 Connect the Eftpos terminal to ATAPower-up the ATA Adjust the Display Orientation of the ATASelect the Required TEI Number Observe D-Channel X.25 Call Progress For the First CallObserve the Software Download Observe for Configuration File ErrorsObserve for Failure to Connect Observe that the ATA is ready and record the service details Replace the ATA if Faulty on ArrivalPoint-to-Point Protocol PPP Installation Click on Control PanelTick Don’t detect my modem I will select from list Installing Dial-Up Network Configuring Dial-Up Networking DUN Open Dial-Up Networking Double click on Make New ConnectionConnect the Eftpos terminal 17 V.120 SetupEnd to end test ATA Maintenance Warranty ATA out of Warranty with Telstra Service Assurance ‘AT’ Commands IntroductionRegister settings Register DescriptionPots Telephone Supplementary Features 5.1 Introduction Abbreviations used in the Pots feature descriptions RSPCall Waiting CW Telephone Port Pots FeaturesMalicious Call Identification Mcid / MCT Call Line Presentation Clip Call Forward Multiple Subscriber Number MSNOH DT #1# telephone number # RH
Top Page Image Contents