Telstrat Argent manual Observe that the ATA is ready and record the service details

Page 12

Argent Terminal Adaptor - User Guide

3.6.12 Observe that the ATA is ready and record the service details

When the above steps have completed successfully, and the configuration is downloaded. There may be a 1-2 minute delay while the ATA activates software, after which the decimal point on the Seven-Segment Display will be illuminated indicating that the unit is now ready for EFTPOS transactions. (NOTE: If the EFTPOS terminal is not yet connected the final display will be a flashing 3 - “No carrier from EFTPOS modem”). After observing this write the following information onto the sticker at the bottom of the unit:

∙Argent EFTPOS service FNN:

FNN = FxxxxxxxxxxY (Argent Dedicated Service) FxxxxxxxxxxT (Argent Test Service)

where xxxxxxxxxx is the 10 digit number of the OnRamp® 2 service.

∙TEI = xx

∙ATA Fault Reporting Number = Service Provider Helpdesk number

∙Date of Purchase = dd/mm/yy

You must call your own Help Desk fault reporting number for any difficulties. This number is supplied with the EFTPOS terminal.

3.6.13 Replace the ATA if Faulty on Arrival

If the ATA is faulty on arrival, see section 3.8 for warranty instructions.

Version 1.1

Telstra Corporation Limited

Page 12/29

ACN 051 775 556

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Version Copyright 1999 Telstra Corporation Limited Table of Contents 24 Serial Port ‘AT’ Commands Introduction Description 3.1 ApplicationPackage Contents DefinitionsBack Panel Port FunctionsTop Panel Seven Segment Display Display InterpretationATA Activation Instructions Prepare positionConnect ATA to NT1 Connect the Eftpos terminal to ATAPower-up the ATA Adjust the Display Orientation of the ATASelect the Required TEI Number Observe D-Channel X.25 Call Progress For the First CallObserve for Configuration File Errors Observe the Software DownloadObserve for Failure to Connect Observe that the ATA is ready and record the service details Replace the ATA if Faulty on ArrivalPoint-to-Point Protocol PPP Installation Click on Control PanelTick Don’t detect my modem I will select from list Installing Dial-Up Network Configuring Dial-Up Networking DUN Open Dial-Up Networking Double click on Make New Connection17 V.120 Setup Connect the Eftpos terminalEnd to end test ATA Maintenance Warranty ATA out of Warranty with Telstra Service Assurance ‘AT’ Commands IntroductionRegister settings Register DescriptionPots Telephone Supplementary Features 5.1 Introduction Abbreviations used in the Pots feature descriptions RSPTelephone Port Pots Features Call Waiting CWMalicious Call Identification Mcid / MCT Call Line Presentation Clip Call Forward Multiple Subscriber Number MSNOH DT #1# telephone number # RH
Top Page Image Contents