Telstrat Argent manual Point-to-Point Protocol PPP Installation, Click on Control Panel

Page 13

Argent Terminal Adaptor - User Guide

3.6.14 Point-to-Point Protocol (PPP) Installation

PPPis used to connect to Internet or other ISDN TAs using the common Windows, Unix, Macintosh interfaces. Most commonly, it is used for Internet access.

PPPover a OnRamp® 2 B-channel can be invoked via the V.24 Serial port, from a Windows 95 PC or similar, by setting up Dial-up networking similar to the configuration of a standard modem.

To use PPP, set up your computer as you would for connecting a standard modem - with no parity, 8 data bits and one stop bit, (ie N, 8,1).

The Argent Terminal adaptor connects to a terminal or computer with a standard modem cable. Plug the D25 male connector into the V.24 / RS232 Serial port on the ATA using a standard straight through modem cable.

Connecting communications equipment, like a modem or router, to the ATA’s V.24 port would require a crossover cable.

Follow the steps below to install the ATA as a Standard Modem

Check Braintree’s website (www.braintree.com.au) for the latest information on installation.

1.Click on START

2.Click on Settings

3.Click on Control Panel

4. Double Click on Modem

Version 1.1	Telstra Corporation Limited
Page 13/29	ACN 051 775 556

Image 13

Contents Version Copyright 1999 Telstra Corporation Limited Table of Contents 24 Serial Port ‘AT’ Commands Description 3.1 Application IntroductionDefinitions Package ContentsPort Functions Back PanelDisplay Interpretation Top Panel Seven Segment DisplayPrepare position ATA Activation InstructionsConnect ATA to NT1 Connect the Eftpos terminal to ATAAdjust the Display Orientation of the ATA Power-up the ATASelect the Required TEI Number Observe D-Channel X.25 Call Progress For the First CallObserve the Software Download Observe for Configuration File ErrorsObserve for Failure to Connect Replace the ATA if Faulty on Arrival Observe that the ATA is ready and record the service detailsClick on Control Panel Point-to-Point Protocol PPP InstallationTick Don’t detect my modem I will select from list Installing Dial-Up Network Open Dial-Up Networking Double click on Make New Connection Configuring Dial-Up Networking DUNConnect the Eftpos terminal 17 V.120 SetupEnd to end test ATA Maintenance Warranty ATA out of Warranty with Telstra Service Assurance Introduction ‘AT’ CommandsRegister Description Register settingsPots Telephone Supplementary Features 5.1 Introduction RSP Abbreviations used in the Pots feature descriptionsCall Waiting CW Telephone Port Pots FeaturesMalicious Call Identification Mcid / MCT Call Line Presentation Clip Multiple Subscriber Number MSN Call ForwardOH DT #1# telephone number # RH