Synopsys 640-pin Generic Device Adapter manual Requirements

The ModelSource 640-pin Adapter Chapter 2: Building the Daughterboard

❍Fourteen #4 lock washers

❍Fourteen #4 flat washers

●One EEProm, Catalyst semiconductor CAT93C86.

Note

The above does not include the package type designation; that is up to the model designer.

●Two Synopsys board stiffeners (short), 600-00193 (or build according to specifications).

●Two Synopsys board stiffeners (long), 600-00XXX (or build according to specifications).

Figure 3 shows a drawing of the short and long board stiffeners.

Short Stiffener

Long Stiffener

Figure 3: Fabrication Drawing of Board Stiffeners

Requirements

●You must locate the connectors and guide pin holes exactly as shown in Figure 1 on page 12, so that the Daughterboard will fit onto the Adapter.

●The height of the DUT above the Daughterboard must not exceed 2.25 inches.

November 2001 Synopsys, Inc. 15