AWS Remote Mode | Solid State Logic X-Logic Series specs

X-Rack Installation and Operation

4.2.4Copy/Swap

While displaying a TR setup pressing and holding a module SEL switch and then pressing a second SEL switch will swap the setting of the two channels.

Selecting COPY/DEL and then doing the same will copy& settings from the first channel to the second.

Note that Copy/S wap is on ly allowed between similar

modules; t he uni t will n ot allow you to swap set tings COPY/

between an EQ m odule an d a Dyna mics module for DEL instance!

4.2.5 Deleting Stores	stores before a SysEx dump) by
Stores can be cleared (to remove unwanted	stores before a SysEx dump) by
holding do wn COPY/DEL till it’s LED	flashes an d pres sing the D-Pot
switch (while still holding down the	COPY/DEL switch). Additional stores
can be de leted by holding dow n the	COPY/DEL switch, selecting th e

second store with the D-Pot and pressing the D-Pot again.

4.2.6Delete All

All st ores ca n be cl eared by holdin g dow n al l three switches unti l their LED s flash, th en pressing the D -Pot switch.

SAVE COPY/

DEL

SEL

COPY/

DEL

SETUP/

MIDI

SEL

Push to Select

4.3 AWS Remote Mode

4.3.1 System Requirements

The X -Rack ‘ TOTAL RECALL LINK IN ’ conn ector must be connected to AWS 900 serial port 1 – see Section 3.3 for more details.

If more than one X-Rack is connected each X-Rack must have a different address – refer to the Setup/MIDI Section.

The AWS900 must be running V1.2/6 or higher software and have Total Recall enabled for this to function. This software can be downloaded from the SSL website.

4.3.2Operation

Pressing the Total Recall STORE switch on the AWS 900 will send a message to all attached X-Racks asking for the current control settings to be returned. The returned settings are appended to th e AWS 900 Total Recall stores and are automatically archived and restored as part of the AWS 900 Total Recall system.

Similarly pressing SELECT in the AWS TR page will return the

selected Total Recall set up to th e X-Rack unit (s). The remote load command will always replace the current setup and the X-

Rack display will read ‘re’. To display the new s ettings, press the D-Pot as in ‘Standalon e’ mode an d to exit display mode press the D-Pot a second t ime. If the AWS 900 store does not contain valid data (for example if it was s aved on an AWS 900 not connected to an X-Rack) the ‘Empty’ LED will light and it will not be possible to select display mode.

Settings can be saved to the local stores and recalled at any time by turning the D-Pot (though see the Remote option in the Setup menu section). Pressing STORE in the TR page on the AWS 900 will always save the current state of the unit and pressing SELECT will replace the store to be displayed with the store from the AWS 900.

See the Remote and the Address options in the Setup/MIDI Section. SELECT

Page 9