Solid State Logic X-Logic Series Operation Total Recall, Stand-alone Mode, Exiting Display Mode

X-Rack Owner’s Manual

4. Operation - Total Recall

4.1 Overview

The Total Recall computer stores all o f the switch and rotary control positions for each X-Rac k module in o ne of th irty two inter nal stores. These c an be recalle d and co mpared with th e current set tings using front panel LEDs to show which controls do not match. If the module layout h as changed since the sn apshot w as tak en, only the modules that match will be recalled.

The contents of all t he stores can be archived and r estored as a MID I system exclusive data dump.

Additionally the X-Rack can in terface with the Total Recall system on an AWS 900 or AWS900+. This allows the settings of up to three X-Rack units to be stored along with the AWS 900 settings.

Note. Through the rest of t his manual, references to ‘AWS 900’ a pply equal ly to ‘AWS 900+’.

TOTAL RECALL

Empty	2
1	3
Wr Prot

4

Push to Select

SAVE COPY/ SETUP/

DEL MIDI

4.2	Stand-alone Mode								5	6	7
4.2.1	Saving Stores to Internal Memory
	A maximum of 32 stores can be saved in internal non-volatile memory, provided the stores have not been
	write-protected – indicated by the ‘Wr Prot’ LED					3	being illuminated.
	First select a store by turning the D-Pot				4 , then press SAVE 5				to
	store all of the current control positions.
	If the store has already been used the SAVE LED will flash. Press the
4.2.2	SAVE 5	switch a second time to overwrite the store.							Push to Select		SAVE
	Recalling and Displaying Stores			then press the D-Pot to select that store.
	To select a store using the D-Pot 4
	The current store is displayed on the dual 7-segment display							1 .
	If the selected store is empty the ‘Empty’ LED 2					lights and the unit will not switch to display mode.
	With a valid s tore selected, the X-Rack mo dule					SEL LEDs will ligh t if the module type in the store (EQ,
	Dynamics etc.) matches the module currently fitted in that slot. A flashing SEL LED indicates that some controls
	on that module do not match the stored positions. A steady LED shows that all controls are matched. The
	switch LEDs will light if the current switch position does not match the stored positions. Press or release
	the switch as required to extinguish the LED.
	Above each rotary control is a bi-colour LED:								The LED lights green if
		The LED lights red if					or
		the co	ntrol needs						the cont rol ne	eds
		turning anti-clockwise.							turning clockwise.
	The LED extinguishes when the control matches the stored position.
	If a st ore is already being displayed when you select a different s tore the display will flash and the new
4.2.3	store will not become active until you press the D-Pot for a second time.
	Exiting Display Mode
	Push the D-Pot 4		a second time to exit display mode.
	All SEL LEDs will extinguish and the channel switch LEDs will now show the position of their respective
	switches.

Page 8