Solid State Logic X-Logic Series Default Midi Controller Mapping, Level Compensation, F-3

Page 53

X-Rack Master Module

•Use the D-Pot to select ‘le’ (MIDI Remote Learn) and press SAVE to enable learn mode.

•Operate any one of the ‘soft’ controls on the XR622 Master module. This will cause the LED of the selected control to flash (the ‘SEL’ LED will flash if either of the potentiomenters have been chosen). Assign a MIDI controller to the selected function by operating the required MIDI controller. Repeat the ‘operate – assign’ process for all required controls.

•Press the D-Pot again to leave this option and return to the setup menu or press and hold SETUP/MIDI until the SETUP/MIDI LED stops flashing to return to normal operation.

•Switch assignments can be reset to the system defaults by pressing COPY/DEL when in MIDI Remote Learn mode; the ‘Empty’ LED indicating when the assignments have been deleted.


Default MIDI Controller Mapping
MIDI Controller		Master Module Control
MIDI Controller		Master Module Control
1		MIX
2		REC
3		EXT
4		ALT
5		MONO
6		DIM
7		CUT
8		AFL Level
9		Monitor LEVEL

Note. These configuration options are also covered in the main X-Rack manual.

Level Compensation

Each of the Insert Send, Mix Bus, Record Bus and Monitor outputs are provided with level compensation for driving low (600Ω) inputs. Level compensation is activated by removing a jumper for each output as follows:


600Ω Output Level Compensation
Link		Output
Link		Output
LK1		Alt/Main Monitor Right
LK2		Record Bus Left
LK3		Record Bus Right
LK4		Alt/Main Monitor Left
LK5		Insert Send Left
LK6		Insert Send Right
LK7		Mix Bus Left
LK8		Mix Bus Right

Page F-3

Image 53

Contents Page Page U N D V I S I O N Solid State LogicSolid State Logic Contents XLogic Warranty Repairs WarrantyOut of Warranty Repairs IntroductionElectrical Safety Warning Safety considerationsInstallation DefinitionsSafety Considerations Graphical SymbolsMains Supply and Phases Mains Isolation and Over-Current ProtectionMounting Rack InstallationAssembling the X-Rack Connection Exiting Display Mode Stand-alone ModeOperation Total Recall Saving Stores to Internal MemoryRack Installation and Operation AWS Remote ModeNavigating in the Setup menu Setup/MIDI ModeOption Display Setting OverviewSaving Setups to a Mac or PC sa Default Midi Controller MappingMidi m1 Midi Remote Channel ckRemote Mode re Write Protect Mode prTest Mode te Address Setting adTest LEDs tl Test Pots tpSet DIM Level d1 Show Version veBefore continuing see System Requirements overleaf Software Download and InstallationAn be downloaded from Rack Internal Links and Fuses Rack Connector DetailsMiscellaneous Rack Connector Details Mix Bus Link Environmental Specification Physical SpecificationPage MIC Section E Rack Mic Amp ModuleLine Section F A-1A-2 3 HF/LF Section GOutput Section H Measurement References Measurement ConditionsMicrophone Amplifier Performance A-3A-4 Instrument Input PerformanceLine Input Performance A-5 A-6 Connector DetailsB-1 Rack EQ ModuleFrequency Sections B-2 Curves PerformanceHF Band controls HMF Band controlsB-4 LMF Band controlsLF Band controls HF EQ Maximum Gain EQ AlignmentHMF EQ Maximum Gain LMF EQ Maximum GainB-6 LF EQ Maximum Gain‘Balance’ Adaptor B-7 B-8 Compressor/Limiter Section Rack Dynamics ModuleGate/Expander Section D-1D-2 D-3 Compressor/Limiter ControlsExpander/Gate Controls D-4 Dynamics AdjustmentsDistortion Compressor Law Compressor ThresholdGate Threshold 7 ‘Balance’ AdaptorD-6 Introduction Line Return ModuleOperation Rack Line Return ModuleE-2 Measurement Conditions Performance SpecificationMeasurement References Line Input PerformanceLine Input Calibration InformationLine E-4Line Connector DetailsInsert Send/Return E-5E-6 Overall width front and rear panels are offsetRack Master Module Master ModuleMix Section F-1Monitor Section Configuration Dim LevelExpansion Midi RemoteLevel Compensation Default Midi Controller Mapping600Ω Output Level Compensation F-3F-4 Mix Bus PerformanceRecord Bus Performance Meter Level Mix Level TrackingHeadphones Connector Details Ins Rtn, Ext, Mon, Alt MonIns Snd, Mix, Rec, Fol Mon F-6F-7 F-8