Socket Mobile 56K Modem Card manual Ending a Data Call

Page 30

3.When the Pocket PC tries to connect, the Power and Data LEDs will blink. After the device connects, it will receive/transmit the information as requested (e.g., Pocket Internet Explorer will display the requested website).

Connection icon: (Navigation bar at top of screen) Indicates an active dial-up or network connection

Modem status icon: (Appears if you installed Socket software)

GREEN — connected

RED — data transmitting

When the Pocket PC is connected, the Link and Power Status LEDS will stay on, and the Data Status LED will blink during data transmission.

Ending a Data Call

1.Tap on the connection icon in the navigation bar at the top of your screen.

2.In the status screen, tap Disconnect. After the Pocket PC disconnects, the connection icon will disappear, and the modem status icon will turn red before disappearing. All LEDs may turn off, depending on your device.

30 CHAPTER 2: SETUP FOR WINDOWS CE

Image 30
Contents 56K Modem Card Table of Contents Page Introduction OverviewPackage Contents Hardware FeaturesSetup for Windows CE Installation Steps SummaryRegister Your Card Prepare Dial-up Information Install the Software Software InstallationSetup for Windows CE Set up the Dial-up Connection Insert the CardGo to Start Settings Connections. Tap on Modem Pocket PCEnter Dialing Settings Country code are correct. Tap on Dialing Patterns Go to Start Settings Connections. Tap on Connections Setup for Windows CE Enter Dialing Settings Country code are correct. Tap on Dialing Patterns Setup for Windows CE Select a modem Socket 56K Modem or Socket-CF+ 56KModem Baud rate Wait for dial tone before dialing Checked Configure… Handheld PC DevicesPort Settings, in the Baud Rate field, select 57600. Tap on Enter Dialing Properties Setup for Windows CE Connect to a Telephone Line Dial and ConnectEnding a Data Call Start Settings Connections ConnectMethod 1 Tap on the Connection icon Setup for Windows CE Method 2 Dial automatically from your application Ending a Data Call Go to Start Programs Communication Remote Networking Optional Set up the Card for Your Country Optional Check Connection Time Pocket PC 2000/2002 and HPC DevicesSetup for Casio BE-300 Install the Software Setup for Casio BE-300 Plug the card directly into a CompactFlash I/O slot Go to Main Connections. Tap on New Setting… Dial-up SelectedSpeed Select 57600 bps Wait for tone Checked Connect to a Telephone Line Ending a Data Call Go to Main WhereAreYou? Optional Set up Advanced Networking Setup for Windows 95/98/Me/2000/XP Insert the Card Install the Drivers NextSet up Your Dial-up Connection Select a device Select Standard Pcmcia Card ModemConnect to a Telephone Line Optional Set up Advanced Networking Properties Appendix a Specifications With CompactFlash-to-PC Card adapterAppendix B Network Information Network Information FormAppendix C Support Resources Technical SupportLive Technical Support Users’ Forum Limited Warranty Limited Software Warranty Copyright Notice Socket Communications, Inc