Socket Mobile 56K Modem Card manual Start Settings Connections

Page 26

Pocket PC 2002

1.After setting up the dial-up connection, you will be in the Connections screen. In the top field, make sure Internet Settings is selected. Tap

Connect.

To access this screen any time, go to:

Start –

Settings –

Connections -

Connections.

2. Make sure the correct User name and Password are entered.

You may need to modify your dial properties. Refer to your Pocket PC 2002’s user manual for instructions.

3.Tap OK. Connection status screens will appear, and the Power and Data LEDS will blink. When the status screen reports that you have Connected, the screen will show two icons.

Connection icon: (Navigation bar at top of screen)

Indicates an active dial-up or network connection

Modem status icon: (Task tray at bottom of screen)

GREEN — connected

RED — data transmitting

When the Pocket PC is connected, the Link and Power Status LEDS will stay on, and the Data Status LED will blink during data transmission.

Ending a Data Call

1.Go to Start Today. Tap on the connection icon in the navigation bar at the top of your screen.

2.In the status screen, tap End. After the Pocket PC disconnects, the connection icon will disappear, and the modem status icon will turn red before disappearing. All LEDs may turn off, depending on your device.

26 CHAPTER 2: SETUP FOR WINDOWS CE

Image 26

Contents 56K Modem Card Table of Contents Page Introduction OverviewPackage Contents Hardware FeaturesRegister Your Card Prepare Dial-up Information Setup for Windows CEInstallation Steps Summary Install the Software Software InstallationSetup for Windows CE Set up the Dial-up Connection Insert the CardGo to Start Settings Connections. Tap on Modem Pocket PCEnter Dialing Settings Country code are correct. Tap on Dialing Patterns Go to Start Settings Connections. Tap on Connections Setup for Windows CE Enter Dialing Settings Country code are correct. Tap on Dialing Patterns Setup for Windows CE Select a modem Socket 56K Modem or Socket-CF+ 56KModem Baud rate Wait for dial tone before dialing Checked Configure… Handheld PC DevicesPort Settings, in the Baud Rate field, select 57600. Tap on Enter Dialing Properties Setup for Windows CE Connect to a Telephone Line Dial and ConnectEnding a Data Call Start Settings Connections ConnectMethod 1 Tap on the Connection icon Setup for Windows CE Method 2 Dial automatically from your application Ending a Data Call Go to Start Programs Communication Remote Networking Optional Set up the Card for Your Country Optional Check Connection Time Pocket PC 2000/2002 and HPC DevicesSetup for Casio BE-300 Install the Software Setup for Casio BE-300 Plug the card directly into a CompactFlash I/O slot Speed Select 57600 bps Wait for tone Checked Go to Main Connections. Tap on New Setting…Dial-up Selected Connect to a Telephone Line Ending a Data Call Go to Main WhereAreYou? Optional Set up Advanced Networking Setup for Windows 95/98/Me/2000/XP Insert the Card Install the Drivers NextSet up Your Dial-up Connection Select a device Select Standard Pcmcia Card ModemConnect to a Telephone Line Optional Set up Advanced Networking Properties Appendix a Specifications With CompactFlash-to-PC Card adapterAppendix B Network Information Network Information FormLive Technical Support Appendix C Support ResourcesTechnical Support Users’ Forum Limited Warranty Limited Software Warranty Copyright Notice Socket Communications, Inc