LIMIT KEY
STEP KEY
ENTERKEY
SEARCH KEY
HOLD KEY
AUTO KEY
This key has two functions in Search Mode:
(a)to step down a frequency; and (b) to set the search band limits. To manually step down, press and hold [LMT]. Press and hold for more than one second to rapidly move down the frequencies.
To set the lower and upper limits of the search band, first enter the number for the
lower limit and press [LMT]. Then enter the number for the upper limit and press [LMT].
Use [STP] to change the step increment when accessing frequencies. Press [STP] to change thE;factory preset auto step to 5 kHz, I 12.5 kHz, 25 kHz, or 50 kHz, or press [.]
twice to reset back to auto steps. (The selected step setting appears on the display.)
(Within the numeric keypad) Press [E] to
store a displayed fre_quency into any displayed channel. Note: If you try to store
the same frequency into another channel, the display will show the original channel for that
frequency. To store the same frequency into
the selected channel, press [E] again.
Press [SRC] to start searching for active frequencies within preset ranges of any band. Normally, the search continues from the frequency where it left off in the previous search. The scanner will automatically start searching upward from the lowest frequency
of its band. ("SRCH" appears on the display in Search Mode.)
During Search, you can press [LMT] to hold the displayed frequency, and press [LMT] again to manually step down a frequency, or
press [HLDl to manually step u~a frequency. ~ress and hold [LMTj or [HLD] to rapidly step through the frequencies.
Press [HLD in Search Mode to stop searching. 'HOLD"appears on the display.)
Press [HLD ~ again to step up one channel. Press and hold[HLD] for more than 1 second to rapidly move through the frequencies. In Hold Mode, press [LMT] to STEP DOWN to the next lower fre9..uency. To resume the search, press [SRCj.
Use [AUTO] to automatically store active frequencies Into open (empty) channels of
specified banks. To use Auto Store, first set the upper and lower limits of the band to be
searched. In Search Mode, press [AUTO] to activate the Auto Store feature. Press the
numeric key(s) for the bank(s) to store the frequencies. ("AUTd' appears on the display
11