Uniden USC 2500XL T manual Ress Manual to stop scanning, Press SRC to start the search

Page 21

~ramming With SEARCH

'ch feature enables you to rapidly search for active jes within the specified band limits. When an

Ig frequency is found, you can store it into a channel t procedure below.

ress [MANUAL] to stop scanning.

Jse the numeric keypad to enter the lower limit and Ipper limit of the band to be searched. (See "Technical 3pecifications" for a list of search bands.)

Note: When you first use the scanner, you must set the search limits before activating SEARCH. Other-

wise, when you try to start SEARCH, error tones are emitted and "Error" appears on the display.

Example: Set search limits of 137.000 to 144.000 MHz.

FIrst enter the lower limit by pressing:

[1] [3] [7] [.] [0] [0] [0]

I'

Press[LMT].

Then enter the upper limit by pressing:

[1][4] [4] [.] [0] [0] [0] Press[LMT].

The search limits of the selected band are now set, and remain in effect even when you turn off the scanner.

3.Press [SRC] to start the search.

Note: During the search, you can manually change the

step increment, if desired. To change the step, press

[STP]one time for each selection: 5 kHz, 12.5 kHz,

25 kHz, or 50 kHz, or press [.] twice to reset to default.

4.When Search stops on an interesting frequency, press

[HLD] to stay on that frequency.

Note: If you press [HLD] again, you step up a frequency. If you press [LMT], you step down a frequency. Press and hold either key to rapidly step through the frequencies.

19

Image 21

Contents USC 2500XL T This equipment contains a Nickel-Cadmium PrecautionsTable of Contents About Your New UBC 2500XLT Leather-like Carrying Case UnpackingWeather Channels Lets your scanner function as a Auto Store Automatically stores all active frequenciesAustralia TopView Controls and IndicatorsFrontView Scan KEY @ @4 Display. Note Youcannotdeactivateall20 banks LMTLIntKV Frequency. To store the same frequency into Send KEY Hold UO WX 1 2 KHz AM NFM WFM IkeylockiSetup Mounting the Flexible Antenna Installing the Belt ClipScanning Overview Bank Scan If you have programmed channels, youBand Search The Search function is different from Programming Channels 0 5Then, press Manual ProgrammingWith the Rotary Tuner If the selected channel already has a stored Frequency Example Set search limits of 137.000 to 144.000 MHz Ress Manual to stop scanningPress SRC to start the search HLD to stay on that frequencyPress Manual to stop scanning Auto Store feature automatically stores all activeFirst enter the lower limit by pressing 4 0 0 Press LMTDisplay. In this case, select another bank ~nother Open ChannelPress E Current channel is erased, and the display shows Deleting a Stored FrequencyPress Manual again Scann ingWeather Channel Scanning Customizing Scanner Operation Press Scan to start scanning This feature is active in Manual Mode or Scan ModeSetting Up Priority Channels To activate the Count feature Using Count to Monitor Channel ActivityTurn the scanner off before removing the Battery Pack Care and MaintenanceEvent of memory loss. If memory is lost, simply Reprogram each channelDo not use excessive amounts of water Clean the outside of the scanner with a mild detergentProblem TroubleshootingSearch Band Technical SpecificationsDisplay 137 174 222 400 520Warranty Unid~n~GP