Uniden USC 2500XL T manual Troubleshooting, Problem

Page 33

Troubleshooting

If your UBC 2500XL T is not performing properly, try the steps listed below.

PROBLEM

Scanner won't work.

Improper reception.

Scan won't stop.

Scan won't start.

Search won't start.

Keypad won't work.

SOLUTION

. Check the power connections.

. Check the volume and squelch.

. Make sure the power switch is turned on.

. Check the antenna connection.

. You may be in a fringe area. Reposition the scanner.

. Adjust the Squelch Control.

. Check the antenna connection.

. It is possible that none of the programmed frequencies are

active at the time. Try the band search.

. Make sure there are some

programmed channels.

. Adjust the Squelch Control.

. Adjust the Squelch Control.

. Check the Keypad Lock.

If you still cannot get satisfactory results and want additional information, or to return the unit for service, please call or write the Uniden Technical Service Division. The address and

phone number are listed in the Warranty (at the end of this manual).

I

31

=I

Image 33
Contents USC 2500XL T This equipment contains a Nickel-Cadmium PrecautionsTable of Contents About Your New UBC 2500XLT Leather-like Carrying Case UnpackingWeather Channels Lets your scanner function as a Auto Store Automatically stores all active frequenciesAustralia TopView Controls and IndicatorsFrontView Scan KEY @ @4 Display. Note Youcannotdeactivateall20 banks LMTLIntKV Frequency. To store the same frequency into Send KEY Hold UO WX 1 2 KHz AM NFM WFM IkeylockiSetup Mounting the Flexible Antenna Installing the Belt ClipScanning Overview Bank Scan If you have programmed channels, youBand Search The Search function is different from Programming Channels 0 5Then, press Manual ProgrammingWith the Rotary Tuner If the selected channel already has a stored Frequency Example Set search limits of 137.000 to 144.000 MHz Ress Manual to stop scanningPress SRC to start the search HLD to stay on that frequencyPress Manual to stop scanning Auto Store feature automatically stores all activeFirst enter the lower limit by pressing 4 0 0 Press LMTDisplay. In this case, select another bank ~nother Open ChannelPress E Current channel is erased, and the display shows Deleting a Stored FrequencyPress Manual again Scann ingWeather Channel Scanning Customizing Scanner Operation Press Scan to start scanning This feature is active in Manual Mode or Scan ModeSetting Up Priority Channels To activate the Count feature Using Count to Monitor Channel ActivityTurn the scanner off before removing the Battery Pack Care and MaintenanceEvent of memory loss. If memory is lost, simply Reprogram each channelDo not use excessive amounts of water Clean the outside of the scanner with a mild detergentProblem TroubleshootingSearch Band Technical SpecificationsDisplay 137 174 222 400 520Warranty Unid~n~GP