Uniden USC 2500XL T manual ProgrammingWith the Rotary Tuner

Page 19

-

6. Press [E] to store the entry.

. If the frequency is already stored in another channel, the other channel will appear on the display. To resolve the conflict, just enter another frequency for the cu"ently selected channel. (Later, we'll discuss how to delete a stored frequency.)

. Any frequency already stored in a channel will automatically be replaced by the new one.

. "Error" appears on the display if an e"or is made during programming, or if the frequency is out of range. To clear the error, enter a valid channel or frequency number.

To program another channel, repeat the above procedures.

B.ProgrammingWith the Rotary Tuner

To program a channel using the Rotary Tuner:

1. If the UBC 2500XLT is scanning, press [MANUAL] to I stop scanning.

2.Select a channel to be programmed by turning the Rotary Tuner to display the channel. (Rotate the control clockwise to step up a channel, or counterclockwise to step down a channel.)

Note: If theChanneVFrequency/LockSelector[CIFIL] . is set to ilL"(lock), turn the control to "C" to enable channel selection using the Rotary Tuner.

3.Turn the Channel/Frequency/Lock Selector to "F" to enable frequency selection.

4.Select a frequency to be stored by turning the Rotary Tunerto display the frequency. (Rotate the control clockwise to step up a frequency, or counterclockwise to step down a frequency.)

Note: When you rotate the Rotary Tuner, the channel selection flashes on the display. This means that the frequency displayed is not programmed in that channel.

5.To store the displayed frequency into the current channel, continue with Step 6

-OR-

To store the displayed frequency into another

selected channel, skip to Step 7

-OR-

To store the displayed frequency into another bank's

open (empty) channel, skip to Step 10.

17

Page 18 Page 20
Image 19
Page 18 Page 20
Contents USC 2500XL T This equipment contains a Nickel-Cadmium PrecautionsTable of Contents About Your New UBC 2500XLT Leather-like Carrying Case UnpackingAuto Store Automatically stores all active frequencies Weather Channels Lets your scanner function as aAustralia TopView Controls and IndicatorsFrontView Scan KEY @ @4 Display. Note Youcannotdeactivateall20 banks LMTLIntKV Frequency. To store the same frequency into Send KEY Hold UO WX 1 2 KHz AM NFM WFM IkeylockiSetup Mounting the Flexible Antenna Installing the Belt ClipBank Scan If you have programmed channels, you Scanning OverviewBand Search The Search function is different from 0 5 Programming ChannelsThen, press Manual ProgrammingWith the Rotary Tuner If the selected channel already has a stored Frequency HLD to stay on that frequency Ress Manual to stop scanningExample Set search limits of 137.000 to 144.000 MHz Press SRC to start the search4 0 0 Press LMT Auto Store feature automatically stores all activePress Manual to stop scanning First enter the lower limit by pressingDisplay. In this case, select another bank ~nother Open ChannelPress E Current channel is erased, and the display shows Deleting a Stored FrequencyPress Manual again Scann ingWeather Channel Scanning Customizing Scanner Operation Press Scan to start scanning This feature is active in Manual Mode or Scan ModeSetting Up Priority Channels To activate the Count feature Using Count to Monitor Channel ActivityReprogram each channel Care and MaintenanceTurn the scanner off before removing the Battery Pack Event of memory loss. If memory is lost, simplyDo not use excessive amounts of water Clean the outside of the scanner with a mild detergentProblem Troubleshooting137 174 222 400 520 Technical SpecificationsSearch Band DisplayWarranty Unid~n~GP
Top Page Image Contents