Uniden USC 2500XL T manual Controls and Indicators, TopView

Page 7

Controls and Indicators

TopView

EmmalChannel!

SpeakerFrequencyl

Lock

Earphone

I

Antenna

OriOlfRotary

VolumeTuner

Connec1Dr

Squelch

EXTERNAL When using an optional External Speaker

SPEAKERJACK system, connect the External Speaker plug here.

EARPHONE

Plug the earphone into this jack for private

JACK

listening.

When the

earphone is connected,

 

the internal speaker is disconnected.

ANTENNA

Connect

the rubber

antenna

to this

BNC

CONNECTOR

connector

and turn

clockwise

until

it locks.

ON-OFFNOLUME(Inner control) This control turns the scanner

CONTROL on or off, and also adjusts the volume.

SQUELCH CONTROL

(Outer control) Adjust the outer control to set the scan threshold. When monitoring a

single channel in Manual Mode, adjust the Squelch Control to eliminate the background rushing noise heard in the absence of an incoming signal.

CHANNEL! (Outer control) Turn the [CIFIL] Selector to FREQUENCY! "C" to enable channel selection, or to "P' to

LOCK SELECTORenable frequency selection. In the "L"

position, the Rotary Tuner is disabled, and cannot be used to select (display) channels

or frequencies.

VFOCONTROL (Inner control) Use the Rotary Tuner to (ROTARYTUNER)select a channel or frequency. Turn the

control clockwise to STEP UP, or counter- clockwise to STEP DOWN, a channel or frequency.

5

Image 7
Contents USC 2500XL T This equipment contains a Nickel-Cadmium PrecautionsTable of Contents About Your New UBC 2500XLT Leather-like Carrying Case UnpackingAuto Store Automatically stores all active frequencies Weather Channels Lets your scanner function as aAustralia TopView Controls and IndicatorsFrontView Scan KEY @ @4 Display. Note Youcannotdeactivateall20 banks LMTLIntKV Frequency. To store the same frequency into Send KEY Hold UO WX 1 2 KHz AM NFM WFM IkeylockiSetup Mounting the Flexible Antenna Installing the Belt ClipBank Scan If you have programmed channels, you Scanning OverviewBand Search The Search function is different from 0 5 Programming ChannelsThen, press Manual ProgrammingWith the Rotary Tuner If the selected channel already has a stored Frequency HLD to stay on that frequency Ress Manual to stop scanningExample Set search limits of 137.000 to 144.000 MHz Press SRC to start the search4 0 0 Press LMT Auto Store feature automatically stores all activePress Manual to stop scanning First enter the lower limit by pressingDisplay. In this case, select another bank ~nother Open ChannelPress E Current channel is erased, and the display shows Deleting a Stored FrequencyPress Manual again Scann ingWeather Channel Scanning Customizing Scanner Operation Press Scan to start scanning This feature is active in Manual Mode or Scan ModeSetting Up Priority Channels To activate the Count feature Using Count to Monitor Channel ActivityReprogram each channel Care and MaintenanceTurn the scanner off before removing the Battery Pack Event of memory loss. If memory is lost, simplyDo not use excessive amounts of water Clean the outside of the scanner with a mild detergentProblem Troubleshooting137 174 222 400 520 Technical SpecificationsSearch Band DisplayWarranty Unid~n~GP