Leica TPS400 user manual Measure or DIST/REC, Exit

Page 11

Proceeding Peg Survey, continued

Sample dialog:

> Step 6

Aim at backsight point and measure.

> Step 7

Enter a desired foresight point number (PtID).

>Step 5 Enter the reflector height (hr) for the backsight point, if required.

[MEASURE] or [DIST]/[REC]		[OK]	Saves the foresight
[MEASURE] or [DIST]/[REC]			point number and
	Angle and distance		point number and
	Angle and distance		proceed to the
	measurements are		proceed to the
	measurements are		measure dialog.
	triggered and stored		measure dialog.
	triggered and stored
	in the internal
	memory.
[SEARCH] Allows users to
	search and choose a
	different backsight
	point.
[EXIT]	Terminates the
	program and returns
	to the start-up menu.

TPS400 Mining Manual-1.0.0en

11

Peg Survey

Image 11

Contents TPS400 Series Quick way to start with the TPS400 Mining Programs Contents Overview Contents Introduction How to use this manualSymbols used in the sequence of operation Known Unknown Peg SurveyIntroduction Before starting Peg Survey Data uploading using Mining EditorStep Start and execution Peg SurveyValid coords Error messagesStation or BS point has no Number of sets Set 1 of total Proceeding Peg SurveySequence Measure Backsight PointExit Measure or DIST/RECRepeat and until all sets are measured DHD ResultsDHz MHDBS/FS Average MHzCoordinates foresight point Results Saving dataResult ResidualFront Line Peg Known GradesStart and execution Grades Slope gradient explained Gradeline Marking Height difference dHgt and horizontal distance dHD explained Grades Result Measurement dataPoint Offset Start and execution Offset Start and execution Offset Offset information Saving dataPolar setout Setting outSetting out coordinates from memory Procedure Orthogonal setout Cartesian setout Polygonal Method Tie DistanceRadial Method Determine second target Result is displayedSoftkeys radial method Softkeys polygonal methodMining Editor Installation on the PCProgram content Mining EditorExample2 Practical ExamplesDefine and upload Tolerances Example1File ! Save As Creating fixpoint files Define tolerancesFile ! Open Process import fixpoint files Second Example Importing of fixpoints in Ascii formatISO standard