Leica TPS400 user manual Tie Distance, Radial Method Determine second target, Result is displayed

Page 29

Tie Distance
The application Tie Distance	Radial Method:			2. Determine second target
computes slope distance,				point.
horizontal distance, height			Slope distance 1-2	Proceed as with first target
difference and azimuth of two			Slope distance 1-3	point.
target points measured online,
selected from the Memory or		Centre point		3. Result is displayed.
entered using the Keypad.		Centre point		Brg	Azimuth between
The user can choose between				Brg	Azimuth between
The user can choose between					point1 and point2.
two different methods:					point1 and point2.
two different methods:			Slope distance 1-4	dSD	Slope distance
			Slope distance 1-4
Polygonal (A-B, B-C)
Polygonal (A-B, B-C)	In principal both methods are				between point1 and
Radial (A-B, A-C)					between point1 and
					point2.
	the same.				point2.
	the same.			dHD	Horizontal distance
Polygonal Method:	Any differences will be			dHD	Horizontal distance
Polygonal Method:	described.				between point1 and
	described.				between point1 and
	Procedure:				point2.
	1.	Determine first target		ddH	Height difference
		point.			between point1 and
	[ALL]		Starts measurement		point2.
	[ALL]		Starts measurement
			to the target point.
	[FIND]		Searches internal
			memory for point
			entered.
TPS400 Mining Manual-1.0.0en			29		Tie Distance

Image 29

Contents TPS400 Series Quick way to start with the TPS400 Mining Programs Contents Overview Contents Introduction How to use this manualSymbols used in the sequence of operation Known Unknown Peg SurveyIntroduction Before starting Peg Survey Data uploading using Mining EditorStep Start and execution Peg SurveyValid coords Error messagesStation or BS point has no Number of sets Sequence Proceeding Peg SurveyMeasure Backsight Point Set 1 of totalExit Measure or DIST/RECRepeat and until all sets are measured DHD ResultsDHz MHDBS/FS Average MHzResult Results Saving dataResidual Coordinates foresight pointFront Line Peg Known GradesStart and execution Grades Slope gradient explained Gradeline Marking Height difference dHgt and horizontal distance dHD explained Grades Result Measurement dataPoint Offset Start and execution Offset Start and execution Offset Offset information Saving dataPolar setout Setting outSetting out coordinates from memory Procedure Orthogonal setout Cartesian setout Radial Method Determine second target Tie DistanceResult is displayed Polygonal MethodSoftkeys radial method Softkeys polygonal methodProgram content Installation on the PCMining Editor Mining EditorDefine and upload Tolerances Practical ExamplesExample1 Example2File ! Save As Creating fixpoint files Define tolerancesFile ! Open Process import fixpoint files Second Example Importing of fixpoints in Ascii formatISO standard