Leica TPS400 user manual Softkeys polygonal method, Softkeys radial method

Page 30

Softkeys - polygonal method:

[NewPt 1] An additional missing line is computed. Program starts again (at point 1).

[NewPt 2] Point 2 is set as starting point of a new missing line. New point (Pt 2) must be measured.

[RADIAL] Switches to radial method.

Softkeys - radial method:

[NewPt 1]	Determine new
	central point.
[NewPt 2]	Determine new
	radial point.
[POLY]	Switch to poly-
	gonal method.

TPS400 Mining Manual-1.0.0en

30

Tie Distance

Image 30

Contents TPS400 Series Quick way to start with the TPS400 Mining Programs Contents Overview Contents How to use this manual Symbols used in the sequence of operationIntroduction Peg Survey IntroductionKnown Unknown Data uploading using Mining Editor Before starting Peg SurveyStart and execution Peg Survey StepError messages Station or BS point has no Number of setsValid coords Measure Backsight Point Proceeding Peg SurveySequence Set 1 of totalMeasure or DIST/REC ExitRepeat and until all sets are measured Results DHzDHD MHz MHDBS/FS AverageResidual Results Saving dataResult Coordinates foresight pointFront Line Peg Grades KnownStart and execution Grades Slope gradient explained Gradeline Marking Height difference dHgt and horizontal distance dHD explained Measurement data PointGrades Result Offset Start and execution Offset Start and execution Offset Saving data Offset informationSetting out Setting out coordinates from memory ProcedurePolar setout Orthogonal setout Cartesian setout Result is displayed Tie DistanceRadial Method Determine second target Polygonal MethodSoftkeys polygonal method Softkeys radial methodMining Editor Installation on the PCProgram content Mining EditorExample1 Practical ExamplesDefine and upload Tolerances Example2Creating fixpoint files Define tolerances File ! Save AsFile ! Open Second Example Importing of fixpoints in Ascii format Process import fixpoint filesISO standard