Leica TPS400 user manual Start and execution Offset, Measure or DIST/REC

Page 25

Start and execution Offset, continued
Definition of offset explained:			> Step 3 Aim at target point		After storing, the
				and measure.	program returns to
					the measuring
	Up		[MEASURE] or [DIST]/[REC]		dialog.
			[MEASURE] or [DIST]/[REC]		If you want to
				Measurement is	If you want to
				Measurement is	measure a new point
				triggered and stored	measure a new point
				triggered and stored	repeat > Step 1
				in the internal	repeat > Step 1
				in the internal	until > Step 3 .
Left	Right			memory.	until > Step 3 .
		z10	[EXIT]	Leaves the
	Down	_		application Offset
	Down	Mining		application Offset
		Mining		and return to the
				and return to the
				menu dialog of "FLP".
	Offset
	Left
Station	Foresight
	Point
	Offset	z11
	Right	Mining
		Mining
TPS400 Mining Manual-1.0.0en				25	Offset

Image 25

Contents TPS400 Series Quick way to start with the TPS400 Mining Programs Contents Overview Contents Symbols used in the sequence of operation How to use this manualIntroduction Introduction Peg SurveyKnown Unknown Before starting Peg Survey Data uploading using Mining EditorStep Start and execution Peg SurveyStation or BS point has no Number of sets Error messagesValid coords Sequence Proceeding Peg SurveyMeasure Backsight Point Set 1 of totalExit Measure or DIST/RECRepeat and until all sets are measured DHz ResultsDHD MHDBS/FS Average MHzResult Results Saving dataResidual Coordinates foresight pointFront Line Peg Known GradesStart and execution Grades Slope gradient explained Gradeline Marking Height difference dHgt and horizontal distance dHD explained Point Measurement dataGrades Result Offset Start and execution Offset Start and execution Offset Offset information Saving dataSetting out coordinates from memory Procedure Setting outPolar setout Orthogonal setout Cartesian setout Radial Method Determine second target Tie DistanceResult is displayed Polygonal MethodSoftkeys radial method Softkeys polygonal methodProgram content Installation on the PCMining Editor Mining EditorDefine and upload Tolerances Practical ExamplesExample1 Example2File ! Save As Creating fixpoint files Define tolerancesFile ! Open Process import fixpoint files Second Example Importing of fixpoints in Ascii formatISO standard