Leica TPS400 user manual Measurement data, Point, Grades Result

Page 22

Results, continued

Saving data

> Step 6

If the sign is negative the grade point are above the measure point.

If the sign is positive the grade point are below the measure point.

Turn the telescope until the height difference (dHgt) is zero, then repeat the measurement

(> Step 5 ).

The following result data are stored in the internal memory:

Measurement data:

Coordinates of new gradeline

PtID:

Point number

point:

 

 

 

Hz:

Horizontal angle

E:

Easting

 

 

V:

Vertical angle

N:

Northing

 

 

HD:

Horizontal distance

H:

Height

 

 

SD:

Slope distance

Grades Result:

dH:

Height difference

daH:

Stake out height

 

 

 

 

 

difference

 

 

daHD:

Horizontal distance

 

 

 

along the foresight

 

 

 

line

 

 

Grd:

Slope gradient

 

 

GE:

Grade elevation

TPS400 Mining Manual-1.0.0en

22

Grades

 

Page 21 Page 23
Image 22
Page 21 Page 23
Contents TPS400 Series Quick way to start with the TPS400 Mining Programs Contents Overview Contents Symbols used in the sequence of operation How to use this manualIntroduction Introduction Peg SurveyKnown Unknown Data uploading using Mining Editor Before starting Peg SurveyStart and execution Peg Survey StepStation or BS point has no Number of sets Error messagesValid coords Measure Backsight Point Proceeding Peg SurveySequence Set 1 of totalMeasure or DIST/REC ExitRepeat and until all sets are measured DHz ResultsDHD MHz MHDBS/FS AverageResidual Results Saving dataResult Coordinates foresight pointFront Line Peg Grades KnownStart and execution Grades Slope gradient explained Gradeline Marking Height difference dHgt and horizontal distance dHD explained Point Measurement dataGrades Result Offset Start and execution Offset Start and execution Offset Saving data Offset informationSetting out coordinates from memory Procedure Setting outPolar setout Orthogonal setout Cartesian setout Result is displayed Tie DistanceRadial Method Determine second target Polygonal MethodSoftkeys polygonal method Softkeys radial methodMining Editor Installation on the PCProgram content Mining EditorExample1 Practical ExamplesDefine and upload Tolerances Example2Creating fixpoint files Define tolerances File ! Save AsFile ! Open Second Example Importing of fixpoints in Ascii format Process import fixpoint filesISO standard
Top Page Image Contents