Leica TPS400 user manual Results Saving data, Residual, Coordinates foresight point

Page 15

Results, continued

Saving data

[OK] Quits the program.

[EXIT] Terminates the measurement and returns to the start- up menu.

The following result data are stored in the internal memory:

Result:
mHz:	Average
	intermediate
	horizontal angle
	between backsight
	point and foresight
	point
mHD:	Average horizontal
	distance (backsight
	and foresight)
mH:	Average height
	(backsight and
	foresight)

Residual:
dHz:	Residual on the
	horizontal angle
dHD:	Residual on the
	horizontal distance
dH:	Height residual

Coordinates foresight point:

E:Easting

N:Northing

H:Height point

GrEl:

Grade Elevation

TPS400 Mining Manual-1.0.0en

15

Peg Survey

Image 15

Contents TPS400 Series Quick way to start with the TPS400 Mining Programs Contents Overview Contents How to use this manual Symbols used in the sequence of operationIntroduction Peg Survey IntroductionKnown Unknown Before starting Peg Survey Data uploading using Mining EditorStep Start and execution Peg SurveyError messages Station or BS point has no Number of setsValid coords Set 1 of total Proceeding Peg SurveySequence Measure Backsight PointExit Measure or DIST/RECRepeat and until all sets are measured Results DHzDHD MHDBS/FS Average MHzCoordinates foresight point Results Saving dataResult ResidualFront Line Peg Known GradesStart and execution Grades Slope gradient explained Gradeline Marking Height difference dHgt and horizontal distance dHD explained Measurement data PointGrades Result Offset Start and execution Offset Start and execution Offset Offset information Saving dataSetting out Setting out coordinates from memory ProcedurePolar setout Orthogonal setout Cartesian setout Polygonal Method Tie DistanceRadial Method Determine second target Result is displayedSoftkeys radial method Softkeys polygonal methodMining Editor Installation on the PCProgram content Mining EditorExample2 Practical ExamplesDefine and upload Tolerances Example1File ! Save As Creating fixpoint files Define tolerancesFile ! Open Process import fixpoint files Second Example Importing of fixpoints in Ascii formatISO standard