Leica TPS400 user manual Before starting Peg Survey, Data uploading using Mining Editor

Page 7

Before starting Peg Survey

Data uploading using "Mining Editor"

•Station coordinates (East, North, Height, Grade elevation)

•Backsight point coordinates (East, North, Height, Grade elevation)

•Tolerances, sequence, number of sets

•Job definition

Uploading of fixpoint coordinates, tolerances, sequence and number of sets is mandatory to enable the operation of "Peg Survey".

To create new jobs on board the instrument, a set of tolerance must be available.

TPS400 Mining Manual-1.0.0en

7

Peg Survey

Image 7

Contents TPS400 Series Quick way to start with the TPS400 Mining Programs Contents Overview Contents Symbols used in the sequence of operation How to use this manualIntroduction Introduction Peg SurveyKnown Unknown Before starting Peg Survey Data uploading using Mining EditorStep Start and execution Peg SurveyStation or BS point has no Number of sets Error messagesValid coords Set 1 of total Proceeding Peg SurveySequence Measure Backsight PointExit Measure or DIST/RECRepeat and until all sets are measured DHz ResultsDHD MHDBS/FS Average MHzCoordinates foresight point Results Saving dataResult ResidualFront Line Peg Known GradesStart and execution Grades Slope gradient explained Gradeline Marking Height difference dHgt and horizontal distance dHD explained Point Measurement dataGrades Result Offset Start and execution Offset Start and execution Offset Offset information Saving dataSetting out coordinates from memory Procedure Setting outPolar setout Orthogonal setout Cartesian setout Polygonal Method Tie DistanceRadial Method Determine second target Result is displayedSoftkeys radial method Softkeys polygonal methodMining Editor Installation on the PCProgram content Mining EditorExample2 Practical ExamplesDefine and upload Tolerances Example1File ! Save As Creating fixpoint files Define tolerancesFile ! Open Process import fixpoint files Second Example Importing of fixpoints in Ascii formatISO standard