Leica TPS400 user manual Results, DHz, Dhd

Page 13

Results

Sample dialog:

[PAGE] Sample dialog:

Tolerances dialog:		[OK]	Leaves this dialog
			and proceed to the
• dHz:	Residual on the		result dialog.
• dHz:	Residual on the
	horizontal angle	[EXIT]	Terminates the
• dHD:	Residual on the		measurement and
• dHD:	Residual on the		returns to the start-

horizontal distance	up menu.

•dH: Height residual

•TolHz, TolHD, TolH: Tolerances horizon- tal angle, horizontal distance and height

•Set No: Set number

TPS400 Mining Manual-1.0.0en

13

Peg Survey

Image 13

Contents TPS400 Series Quick way to start with the TPS400 Mining Programs Contents Overview Contents Symbols used in the sequence of operation How to use this manualIntroduction Introduction Peg SurveyKnown Unknown Before starting Peg Survey Data uploading using Mining EditorStep Start and execution Peg SurveyStation or BS point has no Number of sets Error messagesValid coords Sequence Proceeding Peg SurveyMeasure Backsight Point Set 1 of totalExit Measure or DIST/RECRepeat and until all sets are measured DHz ResultsDHD MHDBS/FS Average MHzResult Results Saving dataResidual Coordinates foresight pointFront Line Peg Known GradesStart and execution Grades Slope gradient explained Gradeline Marking Height difference dHgt and horizontal distance dHD explained Point Measurement dataGrades Result Offset Start and execution Offset Start and execution Offset Offset information Saving dataSetting out coordinates from memory Procedure Setting outPolar setout Orthogonal setout Cartesian setout Radial Method Determine second target Tie DistanceResult is displayed Polygonal MethodSoftkeys radial method Softkeys polygonal methodProgram content Installation on the PCMining Editor Mining EditorDefine and upload Tolerances Practical ExamplesExample1 Example2File ! Save As Creating fixpoint files Define tolerancesFile ! Open Process import fixpoint files Second Example Importing of fixpoints in Ascii formatISO standard