Panasonic PT-LM2E manual Sxga Mode, Back Color, Front/Rear, Desk/Ceiling, FAN Control, Lamp Power

VGA60/525P

VGA60/525P 525P

[

VGA60

When a VGA60 or 525p RGB signal is being input, select the signal in accordance with the input signal.

SXGA MODE

SXGA MODE	SXGA
	[
	SXGA+

This setting is only for an SXGA signal.

SXGA

Select this item normally.

SXGA+

When the edges of the projected image are not visible, select this item.

Noise Reduction (NR)

(S-VIDEO/VIDEO only)

NROFF

[

ON

If noise occurs from the projector because of a poor input signal, set “NR” to “ON”.

To turn off the “NR” feature, set it to “OFF”.

BACK COLOR

BACK COLOR	BLUE
	[
	BLACK

This sets the colour which is projected onto the screen when no signal is being input to the projector.

FRONT/REAR

FRONT/REAR FRONT

[

REAR

This setting should be changed in accordance with the projector setting-up method. (Refer to page 17.)

FRONT

When the projector is placed in front of a screen.

REAR

When using a translucent screen.

DESK/CEILING

DESK/CEILING DESK

[

CEILING

This setting should be changed in accordance with the projector setting-up method. (Refer to page 17.)

DESK

When the projector is placed on a desk or similar.

CEILING

When the projector is suspended from a ceiling using the ceiling bracket (sold separately).

FAN CONTROL

FAN CONTROL STANDARD

[

HIGH

Set “FAN CONTROL” to “HIGH”, when using this projector at high elevations (above 1 400 m) only.

LAMP POWER

LAMP POWER	HIGH
	[
	LOW

This setting changes the lamp brightness. When set to “LOW”, the luminance of the lamp is reduced, but the projector uses less power, and the operating noise is also reduced. This can help to extend the lamp’s operating life. If using the

Adjustments and settings

ENGLISH-43